Manual Batavia BT-CS015 - 7062848 (page 13 of 50) (English, German, Dutch, French)

758290

Zoom out

Zoom in

1/50

English

13. Laser beamer

13.1 Laser beamer in use

The leading beam of the laser beamer

makes sawing in straight lines much easier:

a. along a drawn line, or

b. by aligning it to a xed point marked on

the workpiece.

The range of the laser beam, depending on

the environmental light, is about 65 cm.

13.2 Replacing batteries

• Hold the circular handsaw straight in

front of you. Pull the lid on the laser

beamer towards you, and then lift it.

Replace the batteries with new ones.

You will need 2 x 1.5 V “LR44” batteries.

• Never dispose of old/empty batteries

with the household refuse, but deposit

them instead at special collection point

for batteries or chemical refuse.

• When inserting the batteries, ensure

that the +/- terminals are correctly

placed, as shown inside the battery

compartment.

• Again lower the lid, pull it towards you,

press it against the saw blade cover,

and let it softly spring back into the

closed position.

• Check that the laser beamer is properly

closed by carefully opening the lid

straight upwards. If the lid opens up,

repeat the closing procedure, until the

lid stays properly closed.

13.3 Adjusting the laser beam

• Transport handling and heavy use can

affect the precision of the laser beam.

• The laser beam itself can be easily

adjusted.

• Hold the blade of the circular saw

against a straightedge or perfectly

straight plank.

• Switch the laser on.

• Check whether the laser beam runs

parallel along the edge of the straight-

edge or plank.

If the laser beam is out of alignment, pro-

ceed as follows:

• Loosen the screw on the front side of

the laser a few turns.

• Hold the blade of the circular saw

against a straightedge or perfectly

straight plank.

• Correct the laser such that it runs dead

straight along the edge.

• Again tighten the screw.

14. Cleaning and maintenance

• To avoid injury always pull the power

plug before maintaining or cleaning the

machine.

• Clean the machine with a moist cloth.

• If the machine is very dirty use a mild

detergent or soap on the cloth. Other

cleaning agents may contain chemical

substances which may damage the

plastic parts of the machine.

• Do not allow liquids to enter the

machine and do not immerse the

machine in liquids of any kind.

• Repairs, inspections of the interior of

the machine, adjustments and replace-

ment of the carbon brushes may only

be undertaken by a professional. Only

identical replacement parts may be

used! For further information please

contact our customer service

department.

• Always keep the ventilation slots open

and clean. After each use remove dirt

and contaminations with a brush or

blow it out with compressed air.

• If increased brush re occurs this indi-

cates that the carbon brushes are worn

and should be replaced. Have the

brushes replaced by a professional.

7062848-Circular_Saw_1400W-Ma-1803-19.indb 11 20-03-18 10:39

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Batavia BT-CS015 - 7062848 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,64 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Batavia BT-CS015 - 7062848 Manual

Product: