810506

ATTACK SLX Manual

15
Zoom out
Zoom in
Previous page
1/120
Next page
14
EN
5.4.1 USE OF ANTIFREEZE MIXTURE
It is not recommended to use antifreeze mixture with not suitable quality for the boiler opera-
tion. It is related especially to lowering the heat penetration, big volume expandability, aging,
rubber parts damage. If necessary, use the Alycol Termo (manufacturer Slovnaft Bratislava) anti-
freezing mixture – according to experiences of producer, there is no risk of lowering the safety of
use and noticeable influencing of the boiler work. If this type of protection against freezing is not
achievable in particular conditions, parameters are not fulfiled or there are some boiler failures
caused by use of other antifreezing mixtures, there is no possibility of warranty.
5.4.2 PROTECTION AGAINST CORROSION
Boiler must be connected with device for controlling the tempera-
ture of the boiler reverse. Suitable solution is use of mixing device
ATTACK – OVENTROP (Figure 2), which makes the temperature
rise of the return connection to acceptable level. In this way is
boiler protected against supercooling below 65 °C and creation of
the water steams, acids and tars in the feeding chamber is low-
ered. Mixing device ATTACK – OVENTROP allows to set tempera-
ture of return – water in range of ca. 50 – 70 °C thanks to the
thermostatic head.
Pic. 2 Device for protection of the reverse temperature
ATTACK OVENTROP
NOTICE: If the device against corrosion is not installed in the system or this device does
not work properly, there is a possibility of creation of agressive condensate, which might
lead to the boiler damage. Protection against condensation must be in use during the
boiler operation, otherwise is warranty provided by producer not valid!
Use of the size of ATTACK OVENTROP devices depending on the boiler output:
ATTACK OVENTROP DN25: SLX 20–35 kW
ATTACK OVENTROP DN32: SLX 40–55 kW
5.4.3 OUTFALL OF THE FLUE OUT OF THE BOILER
Flue has to have outfall to the chimney hole. If it is not possible to connect the boiler to the
chimney hole directly, then the appropriate extension should be as short as possible, of up to 1
m length, without any additional heating area and it must ascend to the chimney. It is good to
insulate the flue, to achieve sufficient flue gas temperature and prevent the chimney condensa-
tion. Flues must be mechanically firm (it is recommended to attach the flue to the boiler and bolt
them together) and tight against the flue leakage and cleanable inside. Flues must not lead
through the somebody else's dwelling or commercial premises. The internal diameter of the flue
must not taper in direction to the chimney. It is not eligible to use the elbow connectors. There
must be an „T – shaped“ connection between flue and chimney to let the condensate flow down
to the intended container and not in the boiler.
… 15 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for ATTACK SLX at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of ATTACK SLX in the language / languages: English as an attachment in your email.

The manual is 12.12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of ATTACK SLX

ATTACK SLX Additional guide - English - 21 pages

ATTACK SLX User Manual - German - 112 pages

ATTACK SLX Additional guide - German - 21 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info