702726
7
Zoom out
Zoom in
Previous page
1/12
Next page
Installation
? Copyright 1996 WARNING-Opto-Elektronik GmbH & Co Produktions KG
changes reserved
6
3.1.1 Wiring diagram
distributor
Transmitter
to central
control unit
Receiver
Connection for
earth potential
Screen on both
sides could be
connected with „-„
Screen to be
connected with
earth potential
1.
2.
3.
survey of wiring diagram
Transmitter/Receiver
+ - .
distributor
To central
control unit
to
receiver
to transmitter
screen
connection to supply voltage and
screening
The following items are recommended for the wiring:
1. Connect screen of the supply line leading to the distributor with earth potential.
2. The screen of the supply lines must be connected from the distributor to the devices from
both sides with minus potential. Never connect the screen with earth potential.
3. The housings are to be connected with earth potential.
4. No signals are allowed to be transmitted over the screens.
When inductive load is required at the output an additional protecting circuit must be provided i.e. RC-
component or diode.
3.2 Installation of the equipment
The devices are to be installed on a solid foundation in vertical order. The swivelling optic reduces the
necessity of putting the devices on a common optical axis. For to open the single units untie the screws
at the housing ends and remove the cover carefully. When closing the devices put on the cover carefully
and fasten screws carefully again.
3.3 Mounting with pillars
3.3.1 Ground-plate
Weather influences could effect movements of the ground-plate. Therefore they have to be fixed on a
stable and solid mounting surface. Thus, the ground-plate needs stationary connection. Please pay
attention to the position of the cable inlet to the ground-plate.
Concrete anchor
B25
Ground-plate
800
350
Concrete
anhor
(800)
600
600
(800)
Column´s height Fundament surface
up to 2m (600 x 600) mm
up to 2m (800 x 800) mm
minimum size of the concrete fundament
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech DO510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech DO510 in the language / languages: English as an attachment in your email.

The manual is 0,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info