702726
9
Zoom out
Zoom in
Previous page
1/12
Next page
Alignment
? Copyright 1996 WARNING-Opto-Elektronik GmbH & Co Produktions KG
changes reserved
8
4 Alignment
A red LED has been attached as auxiliary alignment to the receiver which extinguishes by incident IR
beam. For alignment the mirrors can be adjusted horizontally approx. ?95° and vertically ?10°. During
the alignment procedure they have to be moved very carefully and sensitively.
incorrect alignment correct alignment
Luminous
spot
IR-transmitter
diode
alignment via alignment searchlight
For pre-alignment of the trans
mitter and
receiver an ordinary light source (alignment
searchlight or incandescent bulb) can be
applied. Therefore the light-source is fixed
at the receiver res. transmitter at the same
level of the mirror and directed to the
opposite side. Now the mirro
r at the
transmitter and/or receiver can be displaced
until the light-
beam bundled through the lens
(appearing as luminous spot on the yellow
surface) arrives exactly in the middle of the
IR-transmitter and/or IR-receiver diode.
For precision alignment of the receiver the alignment control device (available as accessory in a grey
coloured box)or an oscilloscope can be adapted to the test points (signal and GND) provided therefore (in
the yellow coloured box the connectors have to be adapted visa versa) . The alignment correct as soon
as a maximum of LED’s appears on the alignment control unit.
LED-indicator Evaluation of alignment indicator
1 LED insufficient incident IR-energy
(re-adjust transmitter)
2-3 LED
barely sufficient IR-energy
4-5 LED
well-sufficient IR-energy
6-8 LED
excellent IR-energy
alignment
oscilloscope
2V DC / 100us
GND
test
point for alignment
control unit resp.
oscilloscope
Jumper for
alignment of
alarm response
sensitivity
J1
J2J3
SIG
alignment with oscilloscope
The alignment can also be checked by means
of oscilloscope which must be connected to the
receiver at the test point (SIG) and minus
potential (GND).
The number of impulses on the oscilloscope is
corresponding with the number of LED’s on the
alignment checking device.
Alignment control unit
1 2 3 4 5 6 7 8
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Aritech DO510 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Aritech DO510 in the language / languages: English as an attachment in your email.

The manual is 0,09 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info