719969

Ariston Piccolo Manual

30
Zoom out
Zoom in
Previous page
1/96
Next page
29
GB
Resetting the bipolar safety
In the event of an abnormal overheating of the water, a thermal safety switch in compliance with CEI-EN norms cuts
off the electrical circuit on both the power supply phases of the heating element.
To reset the operation of the appliance, proceed as follows:
- leave it to cool;
- set the knob (F fig. 6) to the maximum temperature position;
- remove the cover C by unscrewing screws D (fig. 4);
- disconnect the thermostat (T fig. 6) from the electricity mains;
- using a cross-head screwdriver, press on point A fig. 9 until you hear it click.
Remount everything in the reverse order, paying particular attention to repositioning the components correctly.
Once the aforementioned operations are complete, make sure you fill the appliance with water before powering
it.
- Avoid positioning any objects and/or appliances that could be damaged by water leaks beneath the water heater.
- Should you not use any water for an extended period of time, you should:
disconnect the appliance from the electrical supply by switching the external switch to “OFF”;
turn off the plumbing circuit taps.
- Hot water at above 50°C flowing out of the taps at the point of use could cause serious scalds or even death from
burns. Children, the disabled and the elderly are more exposed to the risk of burns.
- It is strictly forbidden for the user to perform any routine or extraordinary maintenance.
- Before calling the after-sales service centre for assistance in the event of a suspected malfunction, check first whether
this is due to other causes, such as for example a temporary power failure or water shortage.
See warning nos. 1 - 2 - 3
See warning no. 4 – Contact a competent person for the replacement of the power supply cable.
See warning nos. 5 - 6 - 8
See warning no. 21 - To clean the outer parts of the appliance, use a damp cloth soaked in soapy water.
See warning no. 21 - To clean the outer parts of the appliance, use a damp cloth soaked in soapy water.
See warning nos. 22 - 23
!
!
!
!
!
!
USER INSTRUCTIONS
Advice for user
!
WARNING! Follow the general warnings and the safety norms listed at the
beginning of the text and keep to all the instructions given under all circumstances.
Operation
To turn the water heater on, insert the plug into the wall socket or switch on the bipolar switch.
The pilot lamp (A fig. 4) only stays on during the heating cycle; during this time, the expanding water could cause
some water to trickle from the tap: this is completely normal and does not mean the tap is faulty. Do not screw the
taps too tightly to prevent damaging their seals.
The thermostat will automatically disable the heating element as soon as the selected water temperature is reached.
During the final stage of heating, it is normal for a few cycles of thermostat starting and stopping to take place.
During normal operation, the electric heating element may make a little noise inside the appliance, which is due to
the heat exchange; the plumbing connections may also become hot to the touch.
Adjusting the operating temperature
The temperature of the water can be selected on the knob (F fig. 6) and can be adjusted from 40 to 80°C approximately.
We recommend you set the temperature of the water heater to 60°C to:
- reduce the formation of limescale;
- reduce heat dispersion;
- avoid the risk of bacteria proliferation.
To remount the heating element, the tightening torque of the bolts (A fig. 6) should be between 7 and 10 N/m. You
must respect the “criss-cross” type of tightening.
Once the aforementioned operations are complete, make sure you fill the appliance with water before powering
it.
… 30 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston Piccolo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston Piccolo in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info