719969

Ariston Piccolo Manual

29
Zoom out
Zoom in
Previous page
1/96
Next page
28
GB
The use of multiplugs, extensions or adaptors is strictly prohibited.
It is strictly forbidden to use the piping from the plumbing, heating and gas systems for the appliance earthing
connection.
The appliance is not protected against the effects caused by lightning.
Before turning the appliance on, make sure the supply voltage complies with the value stated on the appliance data
plate and that the appliance itself is filled with water.
If the appliance is not supplied with a power supply cable, make a fixed connection to the mains using a rigid pipe or
cable for permanent installation.
The following operations should be performed annually:
- empty the appliance and dismount the heating element;
- carefully remove all limescale from the heating element parts; if you prefer not to use acids designed especially for
this purpose, use non-metallic objects to break off the limescale crust that has formed, taking care not to damage
the heating element’s armour.
- We recommend you replace the seal each time you dismount the heating element.
The temperature of the water can be selected on the knob (F fig. 6) and can be adjusted from 40 to 80°C approximately.
We recommend you set the temperature of the water heater to 60°C to:
- reduce the formation of limescale;
- reduce heat dispersion;
- avoid the risk of bacteria proliferation.
Starting and testing the appliance
Adjusting the operating temperature
MAINTENANCE REGULATIONS (for competent persons)
!
WARNING! Follow the general warnings and the safety norms listed at the
beginning of the text and keep to all the instructions given under all circumstances.
Anti-freeze function
Replacing parts, when necessary
Periodic maintenance
If the temperatures in the room where the appliance is installed can reach particularly low values, set the knob (F fig.
6) to setting *.
The pilot lamp (A fig. 4) stays on during the heating phase.
Before powering the appliance, fill the tank up with mains water.
Set the knob (F fig. 6) to the desired position, plug the appliance into the socket or switch the main switch to “ON”.
Check the appliance operation until the end of the first heating cycle, indicated by the relative pilot lamp turning off.
During the heating phase, the water expansion could cause some trickling from the tap: this is completely normal and
does not mean the tap is faulty. Do not screw the taps too tightly to prevent damaging their seals.
In the event of a malfunction, read the paragraph regarding the MAINTENANCE REGULATIONS.
All maintenance operations and service visits should be performed by a competent person (who have the
skills required by the applicable norms in force).
Before performing any maintenance operations and/or replacing any components, disconnect the appliance
from the electricity mains using the external switch; empty out the water heater if necessary.
See warning nos. 20 - 26 - 28
!
To access the electrical parts (heating element, thermostat, pilot lamp), remove the cover C by unscrewing screws D
(fig. 4).
In the event of an intervention on the thermostat, disconnect the latter from the electricity mains and slide it out of its
seat on the heating element. In the event of an intervention on the heating element, unscrew the bolts (A fig. 6) using
a 10 mm spanner.
When remounting the components, make sure you put the flange seal, the thermostat, the heating element and all
pipes back in their original position.
We recommend you replace the seal each time you dismount the flange.
Once the aforementioned operations are complete, make sure you fill the appliance with water before powering
it.
… 29 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ariston Piccolo at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ariston Piccolo in the language / languages: English, German, Dutch, French, Italian, Polish as an attachment in your email.

The manual is 1,12 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info