Manual Ariston NUOS 200 SPLIT (page 37 of 104) (English, Dutch, French, Italian)

566471

Zoom out

Zoom in

1/104

Heat pump water heater – INSTALLATION

4.7 Connecting the external unit

Remove the gas connections plastic cover, screw the flare nuts to connect the outdoor unit with the same method

described for the internal unit.

4.8 Making the vacuum, the connection and check the seal (see fig 11).

Bleeding from the circuit should take place with a vacuum pump and pressure gauge assembly suitable for R134a.

Make sure the vacuum pump is full of oil up to the level indicated by the oil gauge.

loose the caps of the taps of the 2 and 3 way valves (E), and of the service valve ©; verify that the two valves on

the outdoor unit are closed (D);

connect the vacuum pump (B) to the service valve (C) by the attack of low pressure gauge (A);

After opened the valves of the vacuum pump (B), start it and let it run. Create a vacuum for about 20 / 25

minutes;

verify that the low pressure gauge (A) indicates a pressure of 1 bar-(or -76 cm Hg);

close the valves of the pump and shut off (B). Verify that the gauge needle does not move for about 5 minutes.

If the needle moves, there are air leaks in the system, then you must check all the tightening and execution of

flare at this point repeat the procedure from step c;

Disconnect the vacuum pump, (if you want to add refrigerant gas see the next paragraph);

completely open the taps on 2 and 3 way valves (D);

Screw in the cap on the service outlet © and valves (E);

after having tightened the plugs, make sure there are no gas leaks with the appropriate detector.

CAUTION: Always protect hoses and cables to prevent their being damaged, as once damaged can cause gas leaks

(personal injury from frostbite).

4.9 Charge of the refrigerant gas (Fig. 11)

The product can be installed with refrigerant connection between internal and external unit up to 8 m. The

warranty does not cover installation with refrigerant connection longer than 8 m. The declared performances

are referred to refrigerant connection pipes of 6 m; different types of installation may lead to different values

of performance.

In case you are adding R134a gas in the circuit, will be needed:

- R134a refrigerant tank. In this case it is necessary a charge attack 1/2 UNF 20 threads per inch and corresponding

seal;

- Electronic scale for refrigerant charging with sensitivity 10g.

Dur

ing installation

Already installed

Through the installer menu activate the C2 (Charge), you

have 30 minutes to perform the charge with the circuit in

low pressure.

Carry out the procedure of paragraph 4

“

create a

vacuum and check the seal” until the passage “f”;

Connect the manometer on the low pressure service valve

, and connect the refrigerant cylinder to the center tap of

the the manometer. Open the container of the refrigerant

then open the main valve cap pressure gauge and adjust

the needle valve until you hear the coolant leak, and

release the pin and close the valve of the the pipe;

Keep under control the weight of the refrigerant tank

through the electronic scale;

Open the ball valve and to flow the refrigerant gradually;

After reaching the mass of gas to be loaded close the tap;

f) Remove the manometer and charging hose from the

valve;

Fully open taps 2 and 3 way valves (D), turn the product in

heat pump mode with the detector and check for leaks of

refrigerant;

Remove the container from the manifold and replace all

the plugs (E).

Connect the manometer on

the low pressure service

valve, and connect the refrigerant cylinder to the center

tap of the the manometer. Open the container of the

refrigerant then open the main valve cap pressure gauge

and adjust the needle valve until you hear the coolant

leak, and release the pin and close the valve of the the

pipe;

b) Keep under control the weight of the refrigerant tank

through the electronic scale;

c) Open the ball valve and to flow the refrigerant gradually;

d) After reaching the mass of gas to be loaded close the tap;

e) Remove the manometer and charging hose from the

valve;

f) with the detector and check for leaks of refrigerant;

g) Remove the container from the manifold and replace all

the plugs (E).

h) Once finished the time for the “Charge”, verify proper

product functioning.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Ariston NUOS 200 SPLIT in the language / languages: English, Dutch, French, Italian as an attachment in your email.

The manual is 2,77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Ariston NUOS 200 SPLIT Manual

Product: