603978
22
Zoom out
Zoom in
Previous page
1/264
Next page
23
GB
469545_a
7. Pull out the starter cord until the engine starts.
8. If the engine does not start, repeat steps 1 to 7.
BC 225 B warm-start (Fig. 8) (Fig. 9)
1. Set the ignition switch to the “Start” position.
2. Set the choke to the „RUN“ position.
3. Pull the starter cord quickly a maximum of 6 times -
the engine will start. Keep the gas lever pressed down
fully until the engine runs smoothly.
Engine does not start:
Set the choke to the “RUN” position.
Pull the starter cord 5 times.
If the engine still does not start:
Wait 5 minutes and then try again with the gas
lever pressed down.
Refer to the “Troubleshooting” chapter.
Switching off the BC 225 B engine (Fig. 8)
4. Release the throttle and allow the engine to idle.
5. Switch the ignition to „STOP“.
Caution!
The engine and cutting tools continue to run on after
being switched off - risk of injury!
Instructions for use
Always let the engine run in the upper speed range during
trimming and cutting.
Safety instructions
Caution!
Observe the safety warnings in this documentation and
on the machine.
Persons who are not familiar with the trimmer should
practise handling it with the engine switched off
Wear appropriate working clothes
Always ensure stability when working.
Always operate the machine with both hands.
Keep body and clothing away from cutting parts.
Keep third parties away from the danger area.
Never hold the string head higher than knee level when
the device is in operation.
Do not spray the unit with water and protect against rain
and humidity.
When mowing on sloping ground, always stand downhill
of the cutting device.
Never work on a slippery hillside or slope.
Neverusethedeviceinthevicinityofhighlyammable
liquidsorgases–Riskofreand/orexplosion!
After contact with a foreign object:
Switch off the engine.
Examine the device for damage.
Lengthening the cutting string
1. Let the engine run at full throttle and tap the string
head on the ground.
The cutting string will be extended automatically.
The blade on the safety shield shortens the cutting
string to the permissible length.
Cleaning the guard
1. Switch off the device.
2. Carefully remove mowing debris with a screwdriver or
similar tool.
Clean the guard regularly to prevent the shaft tube
from overheating.
Trimming
1. Examine the terrain and determine the desired cut-
ting height.
2. Guide and hold the string head at the desired height.
3. Swing the device from side to side in a sweeping,
scythe-like motion.
4. Always keep the string head parallel with the ground.
Close trimming
1. Hold the device so that it is tilted forward at a slight
angle and moves just above the ground.
2. Always trim away from your body.
Trimming along fences and foundations
Caution!
Do not come into contact with solid structures – Danger
of recoil!
1. Move the unit slowly and carefully without allowing the
cutting string to hit any obstacles.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Al-ko BC 225 L at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Al-ko BC 225 L in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 9,63 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info