539677
51
Zoom out
Zoom in
Previous page
1/54
Next page
57
VC3050-001_v02
PROBLEM ACTION
The vacuum cleaner works
poorly.
Remove, empty and clean the
CYKLON dust container, replace
lters, check the suction hose, tube
and the nozzle remove the cause
of clogging.
The electrical installation
fuse went out.
Check if other appliances are not
plugged to the same electrical circuit
as the vacuum cleaner. If the fuse
goes out repeatedly, return the vacuum
cleaner to a service point.
The vacuum cleaner does
not operate; the housing or
the cord is damaged.
Return the vacuum cleaner to
a service point.
Ecology – Environmental protection
Each user can contribute to protect the
environment. It is neither difcult nor expensive.
In order to do so:
Return cardboard packages to recycling
points.
Throw polyethylene (PE) bags into proper
containers.
Return a worn out appliance to a proper collecting point as
the components of the appliance may pose a threat to the
environment.
Donotdisposeofwithhouseholdwaste!!!
The manufacturer/importer does not accept any liability for any
damages resulting from unintended use or improper handling.
The manufacturer/importer reserves his rights to modify the product
any time in order to adjust it to law regulations, norms, directives,
or due to construction, trade, aesthetic or other reasons, without
notifying in advance.
End of operation cleaning
and maintenance
1
Switch off the vacuum cleaner by pressing the “on/off”
button (7).
2
Unplug the appliance.
3
Wind the cord by pressing the cord rewind button (4).
While doing this hold the cord to make sure it is not tangled
and the plug does not hit the vacuum cleaner housing.
4
Disconnect the telescopic tube from the nozzle or brush.
5
Disconnect the telescopic tube from the hose.
6
Press the side button on the end of the hose, then
remove the end of the hose from the inlet hole of the vacuum
cleaner.
7
The vacuum cleaner may be stored in a vertical position
just place the fastening hook of the combination brush
into the fastening of the combination brush. The hose may
be connected to the vacuum cleaner. Yet it is necessary to
make sure it is not bent to hard during storing time.
Horizontal storage:
place the fastening hook of the combination brush into
its fastening placed at the back of the vacuum cleaner,
near the cord exit.
Vertical storage:
place the combination brush on the telescopic tube,
place the fastening hook on the telescopic tube into the
fastening of the combination brush placed on the bottom
of the vacuum cleaner, near the front wheel.
8
Clean the housing and the chamber of the vacuum
cleaner with a wet cloth (it may be wet with washing agent),
the dry them or wipe them dry.
Donotuseabrasivedetergentsorsolvents.
Examples of problems while operating the
vacuum cleaner
PROBLEM ACTION
The vacuum cleaner has
turned off during operation
thermal fuse was
activated.
Do not install the CYKLON
dust container until the
vacuum cleaner cools off.
Turn off the vacuum cleaner, unplug
it and wait ca. 40n minutes before
turning it on again.
Remove, empty and clean the
CYKLON dust container, as well as
the inlet lter cone and the HEPA inlet
lter.
Check and clean accessories:
suction hose, tubes, nozzles and
brushes.
Reassembly all the parts and turn
the vacuum cleaner on.
If the thermal fuse is activated too
often or the vacuum cleaner will not
turn on after cooling, the vacuum
cleaner should be repaired by
a professional in a service center.
G
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Zelmer Pluser VC3050.0 SK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Zelmer Pluser VC3050.0 SK in the language / languages: English, Polish as an attachment in your email.

The manual is 4,07 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info