638626
24
Zoom out
Zoom in
Previous page
1/33
Next page
PYROGAS VARINO 65 - 300
We reserve the right to make changes to dimensions and construction 22 Edition 02.09.2015
© Copyright YGNIS AG CH-Ruswil
6 Desired temperature reached, normal switch off performed via switching hysteresis.
(Active with "fixed value" control, "analog desired value" control or with integrated
heating controller).
8 No or too small gas pressure present, start process was cancelled; condensing unit
checks in 5 min. intervals whether gas pressure is present.
9 Boiler switched off due to exceeding of the electronic temperature monitoring.
A Condensing unit switched off via burner switch on control panel or an external safety
device connected to the boiler control panel has interrupted the control circuit, or the
temperature monitor has been set too low.
C The oxygen sensor is calibrated
d Burner is gauged (can only be reset by service personnel)
E (Without flashing) no signal from oxygen sensor
H Temperature of the oxygen sensor is being checked
9.3. Parameter level
Entry by pressing the PROG key once. The entry is confirmed by lighting up of the point after the 1
st
digit. The
first digit shows the step number and the last two figures the set value.
Step Parameter Setting range
1 Maximum boiler temperature TK in °C 20 to 100°C
2 Min. external temperature TA in °C - 20 to 5°C
3 Min. boiler temperature TK in °C 10 to 60°C
4 Max. external temperature TA in °C 5 to 15°C
Parameter 1 should be set to maximum 85-90°C. 100°C correspond to the safety cut out temperature!
Parameters 2-4 are only active with "fixed value" control
Parameter values are set with the keys + or -. The modified value must be confirmed with the OK key. Switching
to the next parameter takes place via the ►> key. When leaving the parameter level (by pressing the PROG key)
the set values are accepted and overwritten in the EEPROM.
0
10
20
30
40
50
60
70
80
90
100
-20 -15 -10 -5 0 5 10 15
TA (°C)
TK (°C)
24


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ygnis Varino at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ygnis Varino in the language / languages: English as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ygnis Varino

Ygnis Varino Usermanual and installation guide - German - 30 pages

Ygnis Varino Usermanual and installation guide - Dutch - 30 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info