624619
11
Zoom out
Zoom in
Previous page
1/17
Next page
22. 23.
ASSEMBLYASSEMBLY
Place the steel washer on the lower link bolt and
apply pink Loctite (222).
Using two 5mm allen wrenches tighten the lower
link pivot pin. Use a properly calibrated torque
wrench to nish the job.
Torque to 8 Nm
Slide the swingarm into place over the Switch
Innity Link and align the main pivot. Apply a
small amount of grease to the un-threaded part
of the main pivot pin. Apply pink Loctite (222) to
the threads.
05.
06.
08.07.
Slide the main pivot pin through the swingarm
and Innity Link using a Fox Guide Pin to align
the bearing spacer. Use a soft mallet to help
if needed. Lightly thread the pivot pin into the
swingarm using a 10mm allen wrench. Do not
torque yet.
Prepare and install the upper link pivot pin the
same way you install the main pivot pin. Use the
Fox Guide pin to align the bearing spacer as you
slide it through the link. Again, do not torque yet!
Using Fox Guide Pins, install the rear shock as
shown. Insert the guide pins from the drive side.
Lightly grease the shock mounting hardware,
install the appropriate washer and place the
female sleeve over the Fox Guide Pin.
09. 10.
11. 12.
Insert the link and align the lower pivot. Place
the steel washer over the pivot pin, apply a small
amount of grease, and using a Fox Guide Pin to
align the bearing spacer insert the pivot pin. Use
a soft mallet to tap it through if needed.
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yeti Cycles SB6C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yeti Cycles SB6C in the language / languages: English as an attachment in your email.

The manual is 5,79 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info