813461
21
Zoom out
Zoom in
Previous page
1/28
Next page
21
13.6 Remove the connector from the right hand side of the LED
Board, see Diagram 27.
27
To replace the LED Board:
13.7 Connect the new LED Board.
13.8 Angle the LED Board into the front clips. Push down and
rock the LED Board until it clicks into the rear clamps.
IMPORTANT: Test the LEDs before refitting the Fuel
Bed.
14. Replacing the Fuel Bed Motor
14.1 Follow Sections 4, 5, 6, 7 & 8 to access the Fuel Bed Motor
and its connections.
Note: It is advisable to remove the LED Board for ease
of access, see Section 10.
14.2 Remove the Effect Spindle by pulling the rubber sleeve off
the Effect Motor axle, see Diagram 28.
28
B
A
14.3 Remove the 3 screws to release the motor unit bracket,
see Diagram 28 A.
14.4 Remove the 2 screws to release the motor unit,
see Diagram 28 B.
14.5 Slide the motor unit up and out of slots.
14.6 Follow the wires to the corresponding connector and
disconnect the motor unit by squeezing the clips on each
side of the plug, see Diagram 29.
NOTE: The cable clip may need to be removed to gain
access to the connector, ensure this is replaced when
operation is complete.
29
Connector
15. Replacing the Flame Effect Motor
15.1 Follow Sections 4, 5, 6, 7, 8 & 11 to access the Flame Effect
Motor.
15.2 Remove the Effect Spindle by pulling the rubber sleeve off
the Effect Motor axle, see Diagram 30.
30
15.3 Remove the 2 screws to release the motor unit,
see Diagram 30.
15.4 Follow the wires to the corresponding connector and
disconnect the motor unit by squeezing the clips on each
side of the plug, see Diagram 31.
31
Connectors
15.5 Replace in reverse order, ensuring the cable ties are
replaced.
Servicing Instructions
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yeoman Exmoor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yeoman Exmoor in the language / languages: English as an attachment in your email.

The manual is 4.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info