813461
19
Zoom out
Zoom in
Previous page
1/28
Next page
19
Servicing Instructions
9. Replacing the Fuel Bed Effect Spindle
WARNING: The Effect Spindles are sharp, please
use caution when servicing this appliance.
9.1 Follow Sections 4, 5, 6, 7 & 8 to access the Fuel Bed Effect
Spindle.
9.2 The Fuel Bed Effect Spindle is attached to the Fuel Bed
Effect Motor and supported by a bracket, see Diagram 16.
Effect Motor
Support Bracket
16
9.3 The Effect Spindle is attached to the Effect Motor by a
rubber sleeve.
Pull the rubber sleeve off the Effect Motor axle,
see Diagram 17.
17
9.4 Withdraw the spindle from the left hand bracket, see
Diagram 18.
The spindle may need to be tilted to be removed from the
location bracket.
18
9.5 Replace in reverse order.
10. Replacing the Fuel Bed LED Boards
10.1 Follow Sections 4, 5, 6, 7, 8 & 9 to access the Fuel Bed
LED Boards.
10.2 The LED boards are located at the bottom of the appliance.
10.3 Release the LED board from the clips and unplug the
connector to remove.
19
Clip Clip
Connector
10.4 Fitting a new board is the reverse of this process.
IMPORTANT: Test the LEDs before refitting the Fuel
Bed.
When replacing the CN2 connector must be positioned
on the right and connected to the wire.
11. Removing the Effect Screen
11.1 Follow Sections 4, 5, 6, 7 & 8 to access the Effect Screen.
11.2 Remove the screws securing the Effect Screen, see
Diagram 20.
20
Side
Screw
Side
Screw
Screws
11.3 Slide the Effect Screen up and over the 2 side screws to
remove, see Diagram 20.
11.4 Replace in reverse order.
IMPORTANT: When replacing the Effect Screen the side
with the glossy finish must face towards the front of the
appliance with the flames in the correct orientation.
19


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yeoman Exmoor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yeoman Exmoor in the language / languages: English as an attachment in your email.

The manual is 4.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info