813461
23
Zoom out
Zoom in
Previous page
1/28
Next page
23
18. Replacing the RF Receiver
18.1 Refer to Section 4 to remove the Cast Front & Exterior
Glass.
18.2 With the exterior glass removed carefully gather up the fuel
effect and place to one side.
To replace the fuel effect see Installation Instructions
Section 4 for layout.
18.3 Carefully tilt the appliance backwards to access the RF
Receiver.
18.4 Undo the screw securing the RF Receiver to the underside
of the firebox, see Diagram 37.
Underside of
Firebox
37
18.5 Slide the RF Receiver right and remove out of its location.
18.6 Disconnect to remove.
18.7 Replace in reverse order.
19. Pairing the Remote Control
to the Appliance
Signal Code
The below operations should be carried out before
coding when changing to a new remote or the unit
cannot be controlled by the remote:
The reset button is located on the control panel located on
the right-hand side of the viewing window, see Diagram 38.
19.1 Press the reset button for 3 seconds (a pen point may be
needed) until 3 short beeps sound from the unit, release the
button.
Within 10 seconds, press the button on remote. The
coding is finished when 1 long beep sounds from the unit.
Reset Button for
Remote Control
38
Resetting of the remote control is necessary if
the appliance operates incorrectly due to external
interference signal and the remote control is not in use.
20. Resetting the Remote
Resetting the Remote may necessary if the appliance
operates incorrectly under the signal from the Remote, or if
the Remote does not operate correctly.
20.1 Open the back cover of the Remote.
20.2 Press the Reset button for 3 seconds and reset the coding,
see Diagram 39.
39
Servicing Instructions
23


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yeoman Exmoor at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yeoman Exmoor in the language / languages: English as an attachment in your email.

The manual is 4.39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info