689860

Yamaha XV750 Virago Manual

333
Zoom out
Zoom in
Previous page
1/363
Next page
8B-12
Chapter 8 Part B Electrical system (XV700-1100 models)
23.1 The starting circuit cutoff relay is located beneath the seat
(early XV750 shown); it can be identified by its wire colors
23.2 Cutoff relay test connections (1981 through 1983 models)
23.3 Cutoff relay diode test connections
(1981 through 1983 models)
23 Starting circuit cut-off relay - check and replacement
Refer to illustration 23.1
1 Lift or remove the seat (see Chapter 7) and remove the relay (see
illustration).
1981 through 1983 models
Refer to illustrations 23.2 and 23.3
2 Connect an ohmmeter and 12-volt battery to the relay terminals
24.2 Pull back the cover, remove the nut and
disconnect the starter cable
23.5 Cutoff relay test connections (1984 and later models)
(see illustration). The ohmmeter should indicate continuity (little or no
resistance) while the battery is connected, and infinite resistance (no
continuity) when the battery is disconnected.
3 Disconnect the battery and connect the ohmmeter between the
coil winding terminals (see illustration). Note the ohmmeter reading,
then switch the ohmmeter leads. The ohmmeter should indicate very
high resistance in one direction and very low resistance in the other
direction.
4 If the relay doesn't perform as described, replace it.
1984 and later models
Refer to illustration 23.5
5 Connect an ohmmeter and 12-volt battery to the relay terminals
(see illustration). The ohmmeter should indicate continuity (little or no
resistance) while the battery is connected, and infinite resistance (no
continuity) when the battery is disconnected.
6 If the relay doesn't perform as described, replace it.
24 Starter motor - removal and installation
Refer to illustrations 24.2, 24.3 and 24.4
Removal
1 Disconnect the cable from the negative terminal of the battery.
2 Pull back the rubber cover, remove the nut retaining the starter
cable to the starter and disconnect the cable (see illustration).
… 333 …


Need help? Post your question in this forum.

Forumrules
1

Forum

yamaha-xv750-virago

Reset search

  • Hi am Gavin from Napier, New Zealand- Does anyone know the correct clearance between the clutch basket bush and the gearbox input shaft on my 1990 Yamaha Virago xv 750 please? Submitted on 12-12-2021 at 00:03

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha XV750 Virago at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha XV750 Virago in the language / languages: English as an attachment in your email.

The manual is 52,61 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info