557281

Yamaha DSP-E580 Manual

24
Zoom out
Zoom in
Previous page
1/38
Next page
MAIN/CENTER/REAR EFFECT SPEAKER LEVEL
BALANCE ADJUSTMENT
This operation uses an internal test-tone generator for balancing
the levels of the main, center and rear effect speakers. All speakers
should be adjusted to the same apparent sound level for proper
Dolby Pro Logic decoding.
1. Depress the TEST switch on the remote control to enter test
mode. A hiss-like calibration signal should be heard from the left
main speaker, center speaker(s), right main speaker and rear effect
speakers in turn (see diagram). Adjust the MASTER VOLUME to a
normal listening level.
* The state of test-tone output is shown by the display panel and
the monitor screen. (Especially on the monitor screen, it is shown
by an image of audio listening room.) This is convenient for
adjusting each speaker level.
2. Adjust the center and rear effect speaker level.
For adjusting the center speaker level:
Press the SET MENU/PARAMETER select (▲▲) key. “CENTER
LEVEL ··· dB” appears on the display and the test-tone is output from
the center speaker(s). In this state, adjust the center speaker level by
pressing the SET MENU/PARAMETER +/– keys.
For adjusting the rear effect speaker level:
Press the SET MENU/PARAMETER Select (▼▼) key. “SURROUND
LEVEL ··· dB” appears on the display and the test-tone is output from
the rear effect speakers. In this state, adjust the rear effect speaker
level by pressing the SET MENU/PARAMETER +/– keys.
Adjust each speaker level so that the sound coming from the
corresponding speakers seems to be at the same level as that from
the main speakers when you are at a normal listening position.
If there is insufficient volume from the effect speakers, you may
decrease the main speaker volume level by setting the MAIN LEVEL
switch on the rear panel to “–10 dB”, and adjust the center and rear
level again.
NOTE: If the CENTER MODE is set to the PHNTM (phantom)
position, the center speaker level cannot be adjusted. If using a
center speaker, be sure to set the CENTER MODE to the “NRML” or
“WD” position.
After completing this adjustment, press the TEST switch once
again.
NOTE: Once you have completed these adjustments, use only this
unit’s MASTER VOLUME control to adjust listening volume. Do not
change any other volume settings in the system.
22
Left main Center Right main
Rear
LEFT CENTER RIGHT
SURROUND
… 24 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yamaha DSP-E580 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yamaha DSP-E580 in the language / languages: English as an attachment in your email.

The manual is 0,43 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info