OTHER IMPORTANT SETTINGS AND ADJUSTMENTS
IN THE “SET MENU” MODE
The following three types of settings and adjustments should be
done before enjoying audio and video sources. Note that these
settings and adjustments cannot be done without monitoring the
display information (or the information displayed on the monitor
screen).
CENTER MODE
DIMMER
MEMORY GUARD
SETTING/ADJUSTMENT PROCEDURE
1. Select an item (title) of setting/adjustment.
2. Select any desired mode or edit parameters on the item.
In the same way, perform settings/adjustments for other items.
DESCRIPTIONS OF THE ITEMS
1. Selecting Center Mode (CENTER MODE NRML/WD/
PHNTM)
In Normal (NRML) position, any frequency below 100 Hz will be
divided between the main left and main right speakers. For this
reason even a speaker smaller than the main left and right speakers
can obtain a sufficient effect.
In Wide (WD) position, all range of frequencies for the center-
channel are output to the center speaker. Select this position if a
good quality center speaker is being used.
If not using the center speaker(s), be sure to select Phantom
(PHNTM) position, and the audio signals for the center channel are
output to the main speakers.
2. Changing brightness of the display (DIMMER)
You can select one of the five levels of brightness of the display.
3. Locking DSP parameters and other adjustments
(MEMORY GUARD)
If you wish to prevent accidental alteration to DSP parameters or
other adjustments on this unit, select “ON”. In this position, they are
locked and cannot be changed. The following functions on this unit
can be locked by this operation.
• DSP parameters
• Other setting/adjustment items in the “SET MENU” mode
(CENTER MODE/DIMMER)
• TEST switch
23
