478487
107
Zoom out
Zoom in
Previous page
1/132
Next page
VX-3R OPERATING MANUAL 105
SET
(
MENU
)
M
ODE
FUNCTION
Selects the channel step for the fast channel selection mode
while in the Memory Recall mode.
Stores “Alpha-Numeric” tags for the Memory channels.
Enables/Disables the Memory Write Protector.
Selects the Memory Scan, channel-selection mode.
Programming a Member List for the Message feature.
Selects your Personal ID for the Message feature.
Programming a Message for the Message feature.
Set the On Timer Time.
Selects the Opening Message that appears when the radio is
powered on.
Enables/Disables the Answer Back function of the Enhanced
CTCSS Paging & Code Squelch.
Sets the Receiver Pager Code for the Enhanced CTCSS Pag-
ing & Code Squelch.
Sets the Transmitting Pager Code for the Enhanced CTCSS
Paging & Code Squelch.
Program the CTCSS Tone frequency for the User programmed
Reverse CTCSS Decoder.
Enables/Disables the Priority Revert feature.
Selects the time between the Priority (Dual Watch) channel
checks, when the feature is active.
Programs and activates the Password feature.
Selects the time delay before the carrier is transmitted, when
the PTT switch is pressed.
Sets the Repeater Shift Direction.
Sets the magnitude of the repeater Shift.
Selects the Receiving mode.
Selects the Smart Search Sweep mode.
Selects the Receive-mode Battery Saver interval (“sleep” ra-
tio)
Enables/Disables the Transmitter Battery Saver.
Enables/Disables the Scan lamp (while scanning is paused)
Selects the Scan Resume mode.
Select the Scan Re-start Delay time.
Enables/Disables the FM Broadcast audio output to the inter-
nal speaker when using the earphone antenna.
Sets the Squelch threshold level.
Selects the Sub Audible Squelch Type.
Adjusts the Squelch threshold to the S-meter level.
Enables/Disables split CTCSS/DCS coding.
Setting the Dial frequency steps.
Enables/Disables stereo out put, while receiving the FM Broad-
cast band.
Sets the time before Broadcast audio is resumed after the
amateur band signal drops, when the SUB-RX operation is
activated.
Indicates the current temperature inside the transceiver’s case
and selects the measurement units (“°F” or “°C”) for the tem-
perature sensor.
Setting of the CTCSS Tone Frequency.
Setting of the TOT time
Enables/Disables the receiver audio output while the Tone
Search Scanner is activated.
Selects the Tone Search Scanner speed.
Selects or disables the VFO band edge limiting for the current
band.
Set My Band.
Select the DIAL knob function.
Setting of the Wakeup feature.
Enables/Disables the NOAA Weather Alert Feature.
SET MODE ITEM
51
[
MRFSTP
]
52
[
MRNAME
]
53
[
MRPTCT
]
54
[
MRSKIP
]
55
[
MSG.LST
]
56
[
MSG.REG
]
57
[
MSG.SEL
]
58
[
ON TMR
]
59
[
OPN.MSG
]
60
[
PAG.ABK
]
61
[
PAG.CDR
]
62
[
PAG.CDT
]
63
[
PR FRQ
]
64
[
PRI.RVT
]
65
[
PRI.TMR
]
66
[
PSWD
]
67
[
PTT.DLY
]
68
[
RPT
]
69
[
RPT.SFT
]
70
[
RX MD
]
71
[
S SRCH
]
72
[
SAVERX
]
73
[
SAVETX
]
74
[
SCN.LMP
]
75
[
SCN.RSM
]
76
[
SCN.STR
]
77
[
SP OUT
]
78
[
SQ LVL
]
79
[
SQ TYP
]
80
[
SQSMTR
]
81
[
SQSPLT
]
82
[
STEP
]
83
[
STEREO
]
84
[
SUB-RX
]
85
[
TEMP
]
86
[
TN FRQ
]
87
[
TOT
]
88
[
TS MUT
]
89
[
TS SPD
]
90
[
VFO MD
]
91
[
VFO.SKP
]
92
[
VOL MD
]
93
[
WAKEUP
]
94
[
WX ALT
]
AVAILABLE VALUES
(
DEFAULT: BOLD ITARIC
)
10CH / 20CH / 50CH / 100CH
---
ON / OFF
OFF / SKIP / ONLY
---
---
---
OFF / 00H.10M(00:10) - 24H.00M(24:00)
(10 minutes/step)
OFF / DC / MSG
ON / OFF
---
---
300Hz - 3000Hz (1000 Hz/step)
(1600Hz)
ON / OFF
0.1 - 0.9S (0.1S/step) or 1.0S - 10.0S
(0.5S/step) (5.0S)
---
OFF / 20MS / 50MS / 100MS / 200MS
SIMP / -RPT / +RPT
(Depends on the operating band and
transceiver viersion)
0.00 - 150.00 MHz (50 kHz/step)
(Depends on the operating band and
transceiver viersion)
AUTO / N-FM / AM / W-FM
SINGLE / CONT
0.2S - 0.9S (0.1S/step) or 1.0S - 10.0S
(0.5S/step)
ON / OFF
ON / OFF
2SEC - 10SEC / BUSY / HOLD (5SEC)
0.1-0.4S (0.1S/step) or 1.0S - 10.0S
(0.5S/step) (2.0SEC)
AUTO / SPKR
LVL 0 - LVL 15 (AM and N-FM) (LVL 1),
LVL 0 - LVL 8 (LVL 2)
(Wide FM and AM Broadcast)
OFF / TONE / TSQL / DCS / RV TN /
PR FRQ / PAGER / MESSAGE
OFF / LVL 1 - LVL 8
ON / OFF
AUTO / 5 / 8.33 / 9 / 10 / 12.5 / 15 / 20 /
25 / 50 / 100 kHz
STEREO / MONO
OFF / TRX 1S - TRX 10S (1S/step) /
HOLD / TX 1S - TX 10S (1S/step)
---
50 standard CTCSS tones (100Hz)
OFF / 0.5M - 10.0M (0.5M/step) (3.0M)
ON / OFF
SLOW (1.25 tone/sec) /
FAST (2.5 tone/sec)
ALL / BAND
ON / OFF
NORMAL / AUT.BCK
OFF / 5SEC - 60SEC(5SEC/step) / EAI
OFF / ON
107


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Yaesu VX-3R at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Yaesu VX-3R in the language / languages: English as an attachment in your email.

The manual is 4,3 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info