684726
22
Zoom out
Zoom in
Previous page
1/42
Next page
22
EN
Important
If you want to remove the charger from the battery, it’s important that the charging
process is always completely finished. As such, the charging process should only be
stopped when the green LED lights or blinks. If the charging process is interrupted
before it is completed, the battery loses its charge and its acid balance.
When disconnecting the battery or at interruption of the mains voltage, the current
charging process will stop. When a battery is re-connected or the mains voltage is
present again, in both cases a new charging process will start.
When a problem is detected at the start or during the charge process, a number will
appear in the display which indicates a certain error. Consult the ‘Charge Status’ and
‘Trouble Shooting’ for the right actions.
CH AR GE ST AT U S
The charging process can be followed by means of the red, yellow and green LED. If an
error occurs during the charging process an error message will be displayed on the
display.
Consult “Trouble shooting” for the error messages.
Red
LED
Yellow LED Green LED
Error
display
lights blinks lights blinks
Boost X
Equalize X
Compensate X
Float X
Jogging X
Reverse polarisation or
no battery present
1
Battery Voltage too low 2
14 hour limit 3
Temperature protection 4
Battery sulphated 5
Temp.sensor error 6
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xenteq TBC 600 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xenteq TBC 600 in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 3,55 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info