684580

Xenteq LBC 524-5S Manual

21
Zoom out
Zoom in
Previous page
1/58
Next page
21
E N
With the optional mounting clamp PC1 the charger can be
easy placed en taken, without removing the screws each time.
Connection with the battery
Due to the automatic voltage compensation we strongly recommend to leave the
cable length as it is. However, if you want to shorten the cable, it is important
that the length doesn’t become less than 0,7 meter. The cable length can be
extended, but that will also have effect on the automatic voltage compensation.
Use the already wired terminal rings for a fixed connection
with the battery.
For a flexible use you can simply use the supplied
crocodile clamps. This by fixing the clamps to the
terminal rings using the screw connection.
Connect the red wire on the + connection of the battery and the black wire on
the – connection of the battery.
Important
The battery junction that isn’t linked with the frame should be connected
firstly. The other junction must be made with the frame.
When the charger is to be used in an aluminium or steel ship/vessel, it
must be insulated by suspension. That is, in order to avoid electrolysis, the
casing of the charger may not be in contact with the ship.
The connection between the charger and the battery must be made some
distance from the fuel installation.
Advice
It is advisable to mount a fuse between the + pole of the battery and the +
bolt of the charger. Always use a fuse that is heavier than the charge
current.
After installing the charger and setting the charger, the charger is ready for
use.
IN USE
When the charger will be connected to the mains and the set-up mode isn’t
used, the charger will flash two times after 5 seconds and, if the battery is
connected, the charge process will start. When the mains is already present
and the battery will be connected, the charge process will also start
automatically.
The charge process
The LBC 500S standards has a 4-stage process to charge en maintain the
battery the correct way. The charger will always start in the first stage, the bulk
phase (LED red). This first stage has a minimum time length of 30 minutes, so
… 21 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xenteq LBC 524-5S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xenteq LBC 524-5S in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,96 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info