527017

Xenteq EBC-AT SERIE Manual

14
Zoom out
Zoom in
Previous page
1/26
Next page
14
English
The battery is connected to
the charger and the LED’s
burn but the charger does
not work correctly.
Mains voltage is too low.
Measure the mains voltage.
It should be higher than
170VAC.
Weak or no connection
between the battery and
the charger.
Check the connection and
the wires.
Reversed polarization of
the cables.
Remove the connection.
Replace the fuse in the
charger (only use a fuse
with the same value).
Charger is set on the power
supply mode.
Set switch ‘charger/power
supply in the correct
position.
No battery is connected but
the green LED from ‘charge
process’ burns when the
charger is activated.
The charger always gives a
output voltage, irrespective
of the present of a battery.
Switch the charger off.
Always firstly connect a
battery.
The battery isn’t charged
fully, but the charged
indicates the charging
process is finished (float
LED).
The battery is defective.
Measure the acid and, if
necessary, replace the
battery.
The charger doesn’t switch
to float.
The battery is defective.
Measure the acid and, if
necessary, replace the
battery.
Battery cables to thin. Connect thicker cables.
There are heavy consumers
connected to the battery.
Turn off as many users as
possible or connect a
heavier charger.
battery is too heavy for the
charger.
Connect a heavier charger
to the battery.
MAINTENANCE
The charger doesn’t need any specific maintenance. When cleaning the housing, use a
(squeezed) dry cloth. Remove any filth and dust from the ventilation openings of the
charger. Follow the instructions of the manufacturer when using and handling the
battery. CAUTION! A battery contains corrosive sulphuric acid.
Important
Check the charge status of battery charger on a regular basis.
Check the cables and connection between the charger and battery regularly.
Check the ventilation vents en fan on a regular basis.
Check the degree of acidity of a non-maintenance free battery on a regular basis
… 14 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Xenteq EBC-AT SERIE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Xenteq EBC-AT SERIE in the language / languages: English, German, Dutch as an attachment in your email.

The manual is 3,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info