638385
11
Zoom out
Zoom in
Previous page
1/32
Next page
12
G
Safety instructions
Significance of the symbols
Before scarifying
z Never use the machine if persons, especially children or ani-
mals are in the vicinity.
z The operator is responsible for accidents or risks with other
persons or their property.
z Wear ear protection and protective goggles when operating
the machine.
z Only scarify wearing sturdy shoes and long trousers.
z Never scarify in bare feet or wearing sandals.
z Check the ground where the machine is to be used, and remo-
ve any items which could be picked up and thrown out.
1 WARNING - Petrol is extremely flammable
z Only store petrol in containers designated for that purpo-
se.
z Only fill up with petrol in the open air and do not smoke
during filling up.
z Fill up with petrol before starting the engine. When the
engine is running or if the engine is hot, the petrol tank
should not be opened and it should not be topped up.
z If petrol overflows do not try to start the engine.Instead,
clean the machine. All attempts at starting are to be avo-
ided until the petrol vapour has evaporated.
z For safety reasons, the fuel tank caps and silencer should be
replaced if they are damaged.
z Before use, always check by visual examination whether the
working tools are worn out or damaged. To avoid imbalance,
worn or damaged working tools should only be replaced in
complete sets.
When scarifying
z Do not run the engine in enclosed spaces where dangerous
carbon monoxide could build up.
z Only mow the grass if the light conditions are suitable.
z Only guide the machine at walking pace.
z If possible, avoid the use of the unit when the grass is wet
otherwise exercise extreme caution to avoid slipping.
z Always ensure a good position when located on inclined
ground.
z Always work at right angles to the incline, never up and down.
z Take particular care when changing direction on inclined
ground.
z Do not work on ground which has an excessive incline.
z Take particular care when turning the machine or when pulling
it towards you.
z Stop the working tools if:
the machine needs to be tilted for transport.
if areas other than grass are to be crossed
when transporting the machine.
z Never use the machine with damaged or removed protection
devices.
z Make sure that there is adequate distance between your feet
and the working tools.
z When starting the engine do not tilt the machine, unless the
machine needs to be lifted during this process. In this case tilt
only as much as necessary, and only lift the side away from
the operator.
z Never put your hands or feet near the rotating parts.
z Always keep away from the ejection opening.
z Never lift or carry the machine when the engine is running.
z Stop the engine and remove the sparking plug lead:
before removing blockages or obstruction in the ejection
channel,
before checking the machine, cleaning it or doing work on
the machine
if foreign bodies are struck. Check the machine for damage
and undertake the required repair before re-starting and
working with the machine
if the machine starts to vibrate excessively.
when leaving the machine.
before filling up with petrol.
Maintenance and storage
1 Caution! Rotating blades
Before all maintenance and cleaning tasks:
z Remove the sparking plug lead.
z Take care not to grab running cutters.
z Make sure that all nuts, bolts and screws are tightened proper-
ly in order for you to make sure that the machine is in a safe
working condition.
z Never store the machine with petrol in the fuel tank inside a
building in which it may be possible for petrol vapour to come
into contact with fire or sparks.
z Allow the engine to cool down before storing the machine in
enclosed spaces.
z In order to prevent fire, keep the engine free from grass, straw,
moss, leaves or escaping grease.
z Check the machine regularly and replace worn or damaged
parts for safety's sake.
z If the fuel tank needs to be emptied this should be done in the
open air.The drained fuel must be stored in a special container
for fuel or should be disposed of carefully.
Warning!
Read the opera-
ting instructions
before using for
the first time!
Keep third per-
sons away from
the danger area
Caution! - Sharp
cutting blades -
remove plug lead
before mainte-
nance!
Caution! - Dan-
ger of burning -
do not touch the
silencer if the
motor is hot!
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for WOLF-Garten UV 40 H at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of WOLF-Garten UV 40 H in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Swedish, Turkish, Norwegian, Finnish as an attachment in your email.

The manual is 1,26 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info