690821
12
Zoom out
Zoom in
Previous page
1/83
Next page
22 23
EN
Before use
The espresso machine may only be used for its intended purpose in accordance with this instruction
manual. You are therefore advised to read the instruction manual carefully before use, as it provides
instructions for using, cleaning and looking after the device. We accept no liability for any damage
caused if the instructions in this manual are not followed. Keep the instruction manual in a safe
place and pass it on to any subsequent user together with the device. Please also note the warranty
information at the end of the instruction manual.
The safety precautions must be observed during use.
Technical data
Rated voltage: 220-240 V~ 50-60 Hz
Power consumption: 1400 W
Protection class: I
Additional safety information
The device should be connected only to earthed wall sockets that have been installed in accordance
with the regulations. The power cable and plug must be dry.
Do not pull or clamp the connection cable over sharp edges. Do not leave it dangling. Protect it
from heat and oil.
Only use an extension cable if it is in perfect condition.
Never pull the mains plug out of the socket by the cable, always use the plug, and never disconnect
or touch the plug with wet hands.
Do not carry the appliance by the cable.
Do not place the espresso machine on hot surfaces, such as hotplates or the like, or near open gas
flames, as the casing could melt.
Do not place the appliance on water-sensitive surfaces. Splashes of water may damage such
surfaces.
Do not switch the device on without water. Fill the water tank with cold water no higher than the
MAX marker.
If the device will not be used for a longer period of time, pull the mains plug out of the socket.
Stop using the device and/or pull the mains plug out of the socket immediately if:
The device or power cord is damaged
The device is leaking
You suspect that the device may be defective after being dropped or a similar incident.
In such cases, take the device to a specialist workshop to be repaired.
Only operate the device under supervision.
Children should be supervised in order to ensure that they do not play with the appliance.
Descale the device regularly.
We do not accept any liability for damage caused as a result of misuse, incorrect operation,
improper repair or failure to observe the descaling instructions. Warranty claims shall likewise be
excluded in such cases.
Packaging materials, such as plastic bags, must be kept out of the reach of children.
Handy tips
We recommend using freshly roasted coffee in accordance with your personal preferences. Ask your
local coffee retailer for advice. Once it is roasted, coffee does not remain fresh for very long. You can
improve the shelf life of your coffee by packaging it well and storing it in the fridge.
Use fresh water; do not leave the water in the device unused for more than 4 days.
Empty and rinse the water tank regularly (once a week). Always switch the device off before removing
the tank for filling or emptying. Always place the device on a flat, stable surface.
Tips on selecting coffee types
Full aroma:
It is best to choose coffees made from pure Arabica beans or those made primarily from Arabica beans.
Hand-roasted coffees are better because they have more complex and finer aromas. For a change of
flavour, try single-origin coffees.
Strong coffee:
Use coffee blends with Robusta beans – those which are not specified as 100% Arabica – or coffee
described as “Italian Roast” or “Italian Coffee”.
Fill the portafilter to the top with coffee powder and use the tamper to press the powder down.
Getting started
Before using for the first time, clean all the accessories with warm water and gentle dishwashing
liquid and dry.
Then rinse as follows:
1. Connect the device to a mains socket.
2. Take off the lid (A) and remove the water tank (B).
3. Fill the water tank no higher than the MAX marker and place it in the device. The tank must be
correctly positioned. Replace the lid.
4. Make sure the selector switch (G) is set to the O position (G3 ->
).
5. Press the On/Off button (L ->
) to switch the device on. The device runs self-diagnostics.
6. The cup selection buttons (D1/D2 ->
) light up red to indicate that the device is heating up.
When the light rings go from red to white, the device is ready to use.
7. Place a receptacle with a capacity of at least 100 ml underneath the steam outlet (H).
8. Adjust the hot water output knob (G4 ->
) and allow approx. 100 ml water to run out; then reset
the knob to G3 =
.
9. Then prepare 1–2 espressos or 1–2 cappuccinos. Do not drink them.
Perform steps 1–7 in the “Making espresso” section.
12


Need help? Post your question in this forum.

Forumrules
1

Forum

wmf-lumero---12360011

Reset search

  • Why is the 1cup button of lumero WMF blinking color blue? What is the problem? Submitted on 30-1-2022 at 18:15

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wmf Lumero - 12360011 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wmf Lumero - 12360011 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 37,29 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Wmf Lumero - 12360011

Wmf Lumero - 12360011 User Manual - English, German - 19 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info