802116
27
Zoom out
Zoom in
Previous page
1/79
Next page
EN
5110326C_OI-II_Webasto Live 15
The Webasto Live charging station also meters
the plug-in cycles of the charge coupling for ser-
vice purposes and after 10,000 plug-in cycles, dis-
plays a note on the web interface that an electri-
cian needs to inspect the plug contacts on the
charge coupling for any signs of wear. If any signs
of wear are discovered, the electrician must re-
place the affected charging cables with genuine
Webasto spare parts.
Do not attach extension cables or adapters to the
charging cable.
Remove the charging cable by pulling on the
charging coupling only.
Never clean the charging station with a high-pres-
sure cleaner or similar device.
Switch off the power supply before cleaning the
charging sockets.
The charging cable must not be subjected to any
strain during use.
Ensure only persons who have read these operat-
ing instructions have access to the charging sta-
tion.
2.3 Safety information for installation
Installation and connection of the charging sta-
tion must only be carried out by an electrician.
Only use the supplied installation material.
The Webasto Live safety concept is based on a
power supply system that is earthed at all times.
The electrician must ensure this requirement dur-
ing installation.
Do not install the charging station in an explosion
sensitive area (EX zone).
Install the charging station in such a way that the
charging cable does not block any passageways.
Do not install the charging station in areas subject
to ammonia or air containing ammonia.
Do not install the charging station in a location
where falling objects (e.g. extension reel or tyres)
can damage the charging station.
The charging station is suitable for use indoors as
well as outdoors.
Do not install the charging station in the vicinity of
water jets, e.g. car wash installations, high pres-
sure cleaners or garden hoses.
Protect the charging station against damage
caused by sub-zero temperatures, hail or similar.
The charging station is suitable for use in areas
without access restrictions.
Protect the charging station from direct sunlight.
The charging current may be reduced at high tem-
peratures or charging may be disabled completely.
The installation location of the charging station
should be selected such that vehicles cannot inad-
vertently collide with it. Protective measures must
be implemented if the possibility of damage can-
not be ruled out.
Do not place the charging station into operation if
it is damaged during installation. A replacement
will be required.
2.4 Safety information for electrical
connection
Comply with the locally applicable requirements
pertaining to electrical installations, fire protec-
tion, safety regulations and escape routes at the
intended installation location.
Each charging station must be protected with its
own line circuit breaker and residual current circuit
breaker. See chapter6.2, "Criteria for the elec-
trical connection" on page 17.
Make sure that the electrical connections are de-
energised before connecting the charging station
to the power supply.
Make sure that the correct supply cable is used for
the power connection.
Do not leave the charging station unattended
with the cover open.
Register with the power supply company as re-
quired.
2.5 Safety information for initial startup
Initial startup of the charging station must be car-
ried out only by an electrician.
Prior to initial startup, the electrician must check
that the charging station has been connected cor-
rectly.
Do not connect a vehicle during initial startup of
the charging station.
Before startingup the charging station, check the
charging cable, charging coupling and the char-
ging station for visible damage. The charging sta-
tion must not be started up if it is damaged or if
the charging cable/charging coupling is damaged.
3Unit description
Fig.1
These operating and installation instructions describe the
Webasto Live charging station. The exact unit description
is indicated on the type label of the charging station.
3.1 Description of data interface connections
Fig.2
Legend
USB-A
Modbus (RS 485) external
Micro SIM-slot
RJ 45 (LAN)
USB-B
With the cover open, the data interfaces can be found on
the left-hand side in the connection area. This area is
separated from the power supply area.
3.1.1 USB type A
This connection is used in host mode for a USB stick for
software or configuration updates. This connection sup-
ports the 5 V power supply up to maximum 100 mA.
3.1.2 Modbus
The data connection to a primary electricity meter can be
established for advanced power management. (see on-
line configuration instructions: https://webasto-
charging.com/documentation)
27


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Webasto Live at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Webasto Live in the language / languages: English, German, Dutch, Italian, Spanish as an attachment in your email.

The manual is 7.58 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Webasto Live

Webasto Live User Manual - Danish, Swedish, Norwegian, Finnish - 67 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info