Manual Wanders Tali (page 24 of 68) (English, German, Dutch, French)

694512

Zoom out

Zoom in

1/68

Any complaints will be dealt with after the sales rm, the installer or the gas company has led a complaint and sent a copy

of the purchase receipt with purchase date. Any repairs do not entitle you to extend the guarantee term. All consequential

damages or loss are excluded.

Installation instructions for Tali

Your gas replace may only be installed by a qualied installer and must be used in combination with the Wanders (M&G)

concentric channel system. Only then will the replace be approved in accordance with the European CE directive for appliances

burning gaseous fuels. We do not oer a warranty if the gas stove has been connected and/or installed incompletely or

incorrectly. The channel system consists of an inner channel with a diameter of 100 millimetres and an outside channel with

a diameter of 150 millimetres. The ue gases are exhausted outside via the inner 100-millimetre channel through natural

draught, while combustion air is supplied between the 100-millimetre and 150-millimetre channels.

The appliance may only be installed and connected by a certied installer in accordance with the standard gas installation

instructions and the installation requirements mentioned below. Furthermore, the national and local rules and regulations on

placing and using closed gas appliances shall be applicable. Only a certied installer has the authority to change the setting

values (in accordance with the requirements) and to carry out any other adjustments.

Before installing the appliance, the installer must check whether the information on the type tag of the replace

corresponds with the gas type and gas pressure to which the appliance is connected. If it does not match, you

are not allowed to connect the gas hearth.

Placing

The gas replace can be placed in a crack-free and/or mechanically ventilated home without diculty. There is no need for

extra ventilation for combustion or for a smoke and re vent. Waste gases are discharged by natural draught via the inner pipe

into the open. The oxygen needed for burning the re is supplied from the space between the pipes. This is the reason that no

insulation must be placed between the inner and outer pipe.

The Tali must not be built into the wall, and must be placed on a oor that is solid enough to hold the appliance. The distance

from the Tali to the rear wall must be at least 10 cm, and there must be a free space of at least 20 centimetres to the right and

left side of the replace. Be sure to place the Tali on a solid oor plumb under the ue pipe.

Insulation

Due to the high temperatures of the exterior walls (up to approximately 150 °C or 300 °F) it is prohibited to have or to place

any combustible materials close to the channel system. The entire concentric pipe system should be encased with reproof

material from the place where it is out of sight up to the outlet in the exterior wall. Ventilate the encased concentric pipe

system by placing a grate near the oor and the ceiling on every oor. Use universal wall clips with a diameter of 150 mm for

anchoring the concentric pipe system.

If an existing chimney is used, rst make sure whether the chimney is suciently insulated and is wide enough

to accommodate the concentric pipe system. If the chimney was previously used as a wood-burning or coal-red

stove, it must rst be professionally cleaned. You must use special WANDERS connecting sets for connecting a

gas hearth to an existing chimney.

Gas connection

• Use a feed pipe with an approved G3/8” stop cock with coupling.

• De-aerate the supply pipe before tting and fastening the appliance.

• Avoid tension on the operating valve and pipes to avoid gas leakage.

• Check if the connection is gastight.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Tali in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,84 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Wanders Tali Manual

Product: