694512

Wanders Tali Manual

25
Zoom out
Zoom in
Previous page
1/68
Next page
25
GB
Placing the concentric channel system
The combination of the device and the WANDERS concentric channel system (Ø 100 mm - Ø 150 mm) is approved in
accordance with the European CE directive for appliances burning gaseous fuels. Therefore, only this system may be used in
combination with the device. The warranty on the device expires if it is (partly or completely) installed in combination with a
di erent channel system. The WANDERS concentric channel system (Ø 100 mm - Ø 150 mm) can be used in new construction
as well as existing chimneys.
Instructions for placing the out ow
The out ow of the pipe system can be placed on top of the roof or against the side wall of the
house.
Out ow on top of the roof
When placing the out ow on top of the roof, make sure that there is a distance of at least 50 cm
between the out ow and the edges of the roof, with the exception of a possible existing ridge.
You must also take the place of the out ow into account in relation to the existing ventilation
openings, movable windows and combustion air supply provisions. Please consult the national
and local requirements.
Out ow into the wall
When placing the out ow into the side wall, make sure that there is distance of at least 50 cm
between the out ow and the corners of the building, eaves, gutters, balconies and etceteras. You
need not have this distance when the out ow runs to at least the front side of the overhanging
part.
You must also take into consideration the place of the out ow in relation to the
existing ventilation openings, movable windows and combustion air supply
provisions. Please consult the national and local requirements.
Placing possibilities for the pipe system
The total length of the pipe system must never be more than 10 metres excluding the passage through the wall and the
out ow. The maximum horizontal length is 3 metres. A 90° square angle counts as a length of 2 metres. A 45° turn counts as
a length of 1 metre.
For the combined  ue tube and combustion air supply you must apply one of the following set-up possibilities of the WANDERS
concentric pipe systems: with wall duct, with roof duct, or with roof duct with bend.
Because of the high outer temperatures of the  ue system ( around ± 150°C) it’s not allowed to use flammable materials
near the flue system. Therefore it is advised to surround the flue system, on locations where it is not in direct view, with non-
flammable materials. Make sure this construction is sufficiently ventilated (per floor) by installing ventilation grids near the floor
and the ceiling.
It’s not allowed to insulate the concentric  ue system.
Use universal wall brackets Ø150 mm to attach the sleeving of the concentric channel system [Ø 100 mm - Ø 150 mm].
Select one of the connection possibilities. Then build up the  rst metre of concentric pipe from the counterpart in the appliance.
If you can see the blue rubber ring in the pipe from above, you will know that the assembly is correct. Keep a distance of at
least 5 centimetres between the outer wall of the concentric pipe and the ceiling. Always start with 1 meter vertical.
Pay special attention to proper installing when, due to circumstances, a part of the double-walled pipe system must be built in.
Min.
50 cm
Min.
50 cm
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Tali at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Tali in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info