694512
22
Zoom out
Zoom in
Previous page
1/68
Next page
22
GB
Using the hearth for the rst time
When you light your gas hearth for the rst time, the hearth must ‘anneal’. The unit has a heat-resistant lacquer which must
still burn in. Though this may give an unpleasant smell, it is otherwise harmless. It is advisable to burn the stove at its highest
position for about three hours while airing the room well.
Discolouration of walls, ceilings and grates
After lighting your hearth, the walls, ceilings and grates may show some discolouration. This is caused by the
dust particles that burn in the convection cover. This is a natural process for which WANDERS cannot be held
responsible. To minimize discolouring we refer to the advice given for atmospheric hearths. Your installer can
give you more information about this.
Some deposit may form on the ceramic glass of the door of the hearth. You can easily remove this deposit with a damp cloth
when the glass is cold. If necessary you can use a special cleansing agent for ceramic rings. Page 27 shows you how to remove
the glass.
Watch out for nger marks!
Make sure to leave no nger marks on the cleaned glass pane when you close the hearth door. Finger marks
leave stains which will burn in the glass.
When you ignite the hearth for the rst time, the hearth calculates how much time is needed to reach the preset temperature.
On this basis, the hearth selects the most ecient way to heat the room.
Ensure that no logs are placed in front of the pilot ame. The gas must be able to ow unobstructed to the main
burner. The main burner is located underneath the log set. See page 28 for placing the ceramic log set properly.
It is advisable to keep the pilot ame alight in heating season to prevent condensation and possible calcication
on the inside of the door.
Newly-built house or recently renovated?
It is advisable to wait six weeks before lighting the hearth in a newly-built house that has recently been delivered,
or in a space that has recently been drastically renovated. The walls and ceilings still contain gases, softeners
and moist from plasterwork or paint. The warm air-streams may discolour the dust particles in the space which
may stick to walls and ceilings. When the moist in the walls and ceilings warm up it may also cause yellowish
stains.
Maintenance
Small maintenance
Avoid the air in your room to be lled with dust particles from tabacosmoke, candles and oillamps. These particles, when
burned near the appliance may settle as discolloration on the walls and ceiling. Ventilate the room where the appliance is
installed as much as possible. Remove any dirt and dust with a vacuum cleaner. Clean the outside only when the hearth is cold.
If coee or something else has spilt on the ornamental moulding while the hearth is burning, turn the unit o immediately.
When the hearth has cooled o, you can remove any stains with a damp cloth.
Do not use any aggressive cleaning agents or abrasives and do not apply any stove polish.
Annual maintenance
Your gas hearth needs to be checked and maintained by a certied installer at least once a year. He will check the following:
The air-tightness of the exhaust pipes for gas and fumes and the combustion air supply pipe.
The proper functioning of the gas control block, the thermocouple interrupter (a safety measure against unexpected outow
of gas) and the ignition of the main burner.
The entire pipe system, including the exterior wall or roof duct and the external outlet.
22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Tali at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Tali in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 5,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info