571834
21
Zoom out
Zoom in
Previous page
1/64
Next page
21
GB
10. Turn motor switch all the way to the right to put out the re; the pilot ame will keep burning.
11. If you want to put out the pilot ame as well, turn O I switch to the O position.
12. Close the gas tap.
Using the hearth for the rst time
When you light your gas hearth for the rst time, the hearth must ‘anneal’. The unit has a heat-resistant lacquer
which must still burn in. Though this may give an unpleasant smell, it is otherwise harmless. It is advisable to
burn the stove at its highest position for about three hours while airing the room well.
Discolouration of walls, ceilings and grates
After lighting your hearth, the walls, ceilings and grates may show some discolouration. This is caused
by the dust particles that burn in the convection cover. This is a natural process for which WANDERS
cannot be held responsible. To minimize discolouring we refer to the advice given for atmospheric
hearths. Your installer can give you more information about this.
Some deposit may form on the ceramic glass of the door of the hearth. You can easily remove this deposit with
a damp cloth when the glass is cold. If necessary you can use a special cleansing agent for ceramic rings. Page
27 shows you how to remove the glass.
Watch out for nger marks!
Make sure to leave no nger marks on the cleaned glass pane when you close the hearth door. Finger
marks leave stains which will burn in the glass.
When you ignite the hearth for the rst time, the hearth calculates how much time is needed to reach the
preset temperature. On this basis, the hearth selects the most ecient way to heat the room.
Ensure that no logs are placed in front of the pilot ame. The gas must be able to ow unobstructed
to the main burner. The main burner is located underneath the log set. See page 28 for placing the
ceramic log set properly.
It is advisable to keep the pilot ame alight in heating season to prevent condensation and possible
calcication on the inside of the door.
Newly-built house or recently renovated?
It is advisable to wait six weeks before lighting the hearth in a newly-built house that has recently
been delivered, or in a space that has recently been drastically renovated. The walls and ceilings still
contain gases, softeners and moist from plasterwork or paint. The warm air-streams may discolour
the dust particles in the space which may stick to walls and ceilings. When the moist in the walls and
ceilings warm up it may also cause yellowish stains.
!
!
!
!
!
21


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Wanders Balsa 100 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Wanders Balsa 100 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 9,54 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info