540490

Vortex Razor HD 5-20x50 Riflescope Manual

8
Zoom out
Zoom in
Previous page
1/13
Next page
15
14
12 13
Place the riflescope on bottom ring halves and loosely install
the upper ring halves. Before tightening the scope ring
screws, adjust for maximum eye relief to avoid injury from
recoil:
Eye Relief and Reticle Alignment
1. Set the riflescope to the middle of its magnification range.
2. Slide the riflescope as far forward as possible in the rings.
While viewing through the riflescope in a normal shooting
position, slowly slide the riflescope back towards the shooter’s
face—paying attention to the field of view. Just as the full view
becomes visible, stop.
3. Without disturbing the front-back placement, rotate the
riflescope until the vertical crosshair exactly matches the
vertical axis of the rifle. Use a reticle leveling tool, hanging
weight on a rope (see next page), or an adjustable set of feeler
gauges for this procedure.
4. After aligning the reticle, tighten and torque the ring screws
down per the manufacturer’s instructions.
Bubble Level
After the riflescope is in the rings and the reticle matches
the vertical axis of
the rifle, the bubble
level may be mounted
to the riflescope
tube. Attach the level
to a location on the
scope tube that allows
good visibility while
in shooting position
and does not block
view of parallax or
windage knobs. Most
shooters will prefer
mounting the level on
the forward section of
the riflescope tube.
1. Confirm the vertical orientation of the reticle by hanging
a weight from a heavy cord at a distance out in front of the
riflescope.
2. Visually level the bubble between lines and tighten screws
using thumb and forefinger on short end of hex wrench.
Confirm the vertical orientation of the reticle.
Bubble Level
Vertical Reference
Use of an adjustable set
of feeler gauges between
a one-piece base and
flat bottom section of the
riflescope to square the
riflescope (and reticle) to
the base.
Example of Squaring the Riflescope
… 8 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Vortex Razor HD 5-20x50 Riflescope at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Vortex Razor HD 5-20x50 Riflescope in the language / languages: English as an attachment in your email.

The manual is 2,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info