Manual Viking MT 6112ZL (page 15 of 290) (English, Portuguese, Spanish)

667337

15

Zoom out

Zoom in

Previous page

1/290

Next page

ENES

13

PTEL

0478 192 9807 C - EN

Before reversing, always check the area

behind the ride-on mower and, if present,

disengage the attachment. Never mow in

reverse, if it is not absolutely necessary.

When mowing in reverse, take particular

care and before beginning to mow,

thoroughly check the entire area behind

the ride-on mower.

When working together in a group, always

inform the others in advance of what you

intend to do. Maintain a safety distance!

The vehicle speed must be reduced before

each change of direction, so that the user

retains control of the machine at all times

and also that the ride-on mower cannot tip

over.

When operating near to roads and when

crossing roads, other road users must be

taken into account.

Take particular care when mowing near

roads, cycle paths and footpaths. Objects

which are thrown up by the mower can

cause severe injury and damage.

Only empty the grass catcher box from the

driver's seat.

Before emptying the grass catcher box,

always disengage the mowing blades and

wait until they have come to a standstill.

When operating the ride-on mower with

attachments, always follow the

instructions and safety regulations

supplied with the attachments.

Switch off the drive, stop the engine and

wait until the mowing blades have come to

a complete standstill, engage the parking

brake and remove the ignition key:

– When leaving or transporting the

machine.

– Before remedying blockages, including

those in the discharge chute.

– Before checking, cleaning or working

on the ride-on mower.

– If the mowing blades have hit an

obstacle.

Inspect the machine and the cutting tool

for damage and have any necessary

repairs performed before re-starting.

Additionally check the installation

position of the mowing blades on the

models MT 5112 Z, MT 6112 C,

MT 6112 ZL, MT 6127 ZL – the mowing

deck must not be engaged if the angle

of the blades relative to each other is

not as specified in the chapter "Mowing

blade maintenance". (Ö 15.13)

– If the machine begins to vibrate

excessively. It must be checked

immediately.

Stop the engine and wait until the mowing

blades have come to a complete standstill:

– Before filling with fuel.

– Before removing the grass catcher box.

– Before opening the engine hood.

Driving with cruise control:

Activating cruise control in the wet or

under adverse ground conditions as well

as when pulling loads increases the

accident risk.

When cruise control is switched off, the

ride-on mower brakes abruptly.

Cruise control is an aid that provides

assistance when driving. The

responsibility for the driving speed and for

timely braking always lies with the user.

Cruise control does not react to obstacles

or to altered ground conditions. If an

obstacle cannot be avoided at the set

driving speed, cruise control must be

switched off.

Due to the increased risk of accident,

cruise control must not be used:

– In situations which do not permit driving

at constant speed (e.g. adverse ground

conditions due to wet conditions or on

slopes).

– On slippery surfaces. The wheels may

lose their grip and the vehicle can skid.

– If visibility is poor (e.g. due to fog, heavy

rain or at night).

Working on slopes:

Slopes are one of the major causes of

accidents in which control over the ride-on

mower is lost causing it to tip over, which

can result in severe or even fatal injuries.

There is no "safe" slope! Driving on grassy

slopes requires special concentration.

For safety reasons, the machine must not

be used on slopes with an inclination of

more than 10° (17.6 %). Risk of injury!

A slope inclination of 10° corresponds to a

vertical height increase of 17.6 cm for a

100 cm horizontal distance.

In order to ensure an adequate oil supply

for the engine, the information in the

accompanying engine instruction manual

must be additionally observed when using

the machine on slopes.

If you cannot drive up the slope in reverse

or if you have doubts regarding safety, you

should not drive on the slope.

1

MT6112C
I get continuity when i connect M(agneto) and G(round) terminals in Stop position on ignition key, so great. But in the block that connects to it, the slot is empty, and te diagram shows LASBYM without any wire going to M. Could you explain please? Submitted on 16-5-2023 at 16:49
Reply Report abuse
how to remove a flat battery from vikking ride on
Submitted on 2-12-2022 at 16:14
Reply Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Register

Register getting emails for Viking MT 6112ZL at:

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Viking MT 6112ZL in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 24,74 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Viking MT 6112ZL

Viking MT 6112ZL User Manual - German, Dutch, French, Italian - 284 pages

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info