667332

Viking MT 5097 Manual

34
Zoom out
Zoom in
Previous page
1/290
Next page
0478 192 9807 C - EN
32
To start the engine, the following
conditions must always be fulfilled:
– The discharge chute must be correctly
installed.
– The brake pedal must be pressed or the
parking brake engaged.
The engine is switched off if the user:
– Leaves the driver's seat with the
mowing deck engaged.
– Lifts the grass catcher box or removes
the deflector (special accessory) with
the mowing deck engaged.
– Removes the discharge chute with the
mowing deck disengaged.
– Leaves the driver's seat without
engaging the parking brake.
Integrated blade run-down brake:
MT 5097, MT 5097 C, MT 5097 Z,
MT 5112 Z, MT 6112 C, MT 6112 ZL:
Following disengagement, the mowing
blades come to a standstill after 5
seconds at the latest.
MT 6127 ZL:
Following disengagement, the mowing
blades come to a standstill after 7
seconds at the latest.
● Familiarise yourself with the controls on
the machine before using it. (Ö 8.)
● Before operating the machine, inspect
the maintenance schedule and carry
out all relevant maintenance
operations. (Ö 15.1)
● Check the safety devices before each
use. (Ö 12.)
The ride-on mower must not be
operated if safety devices are missing
or damaged or have been bypassed or
modified.
13.1 Filling the fuel tank
Maximum tank capacity:
9litres
Recommendation:
Fresh good quality fuel, please
refer to the engine instruction manual for
information on fuel grade (octane rating).
– Unleaded petrol.
Filling procedure:
● Stop the engine and allow it to cool
down (warm to the touch). (Ö 13.3)
● Engage the parking brake. (Ö 8.14)
Pour in the fuel slowly and carefully. In
order to prevent the fuel from overflowing,
filling should be performed in several
stages.
Remove the funnel between the individual
filling operations in order to visually check
the filling level in the tank.
The more fuel has already been filled into
the tank, the smaller the filling quantities
should be for each filling operation. To give
the fuel room to expand, never fill the fuel
tank past the lower edge of the filler neck.
Tank cap:
Unscrew the tank cap (1) (note direction of
arrow) and remove.
● Fill the fuel into the tank using a suitable
funnel (not included in standard
equipment) (see Filling procedure).
Following engagement of the
mowing deck, the mowing blades
turn and a wind noise is audible.
The run-on time corresponds to the
duration of the wind noise following
disengagement. This can be
measured using a stopwatch.
13. Operating the machine
Risk of injury!
Carefully read and observe the
entire section "For your safety"
before operating the machine.
(Ö 4.)
For safety reasons, the machine
must not be used on slopes with an
inclination of more than 10°
(17.6%).
A slope inclination of 17.6%
corresponds to a vertical height
increase of 17.6 cm for a 100 cm
horizontal distance.
To prevent fuel spillage, use a
suitable funnel (not included in
standard equipment) when filling
up.
… 34 …


Need help? Post your question in this forum.

Forumrules
1

Forum

viking-mt-5097

Reset search

  • how do i replace the transmission cable on the Viking MT 5097.oz Serial number 980075680
    Submitted on 4-10-2024 at 18:46

    Reply Report abuse

  • I need to change the ground drive belt in my MT 5097. Are there any instructions available for this? Submitted on 4-4-2022 at 18:58

    Reply Report abuse

  • I need to replace the drive belt in my MT 5097. Are there any instructions available for this? Submitted on 4-4-2022 at 18:57

    Reply Report abuse

  • Hello,
    We Have a Viking MT 5097Z.
    The engine stopped at once.
    When i turn on the Key to run it, the 10A fuse melts (twice) - not the 15A fuse.
    Is it possible one relay is broken (short-circuit) ? - N° 18,19, 25, 26 on the electric map -
    Or what other possibility?
    Thank's for your answer
    Best regards
    Franck
    Submitted on 4-1-2022 at 12:40

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MT 5097 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MT 5097 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 24,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Viking MT 5097

Viking MT 5097 User Manual - German, Dutch, French, Italian - 284 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info