667214

Viking ME 443 Manual

43
Zoom out
Zoom in
Previous page
1/250
Next page
41
DEFRNLITESPTNOSVDAELRU EN
0478 121 9920 D - EN
● Attach the grass catcher box. (Ö 8.3)
11.6 Working area for operator
● For safety reasons, the operator
must stay within the working area
behind the handlebar when the motor is
running. Always observe the safety
distance provided by the handlebar.
● The lawn mower must only be operated
by one person. Other persons must
keep out of the danger area. (Ö 4.)
12.1 General
Annual service by the specialist dealer:
The lawn mower should be inspected once
annually by a specialist dealer. VIKING
recommends VIKING specialist dealers.
12.2 Cleaning the machine
Maintenance interval:
After each use
● Only clean the machine using water,
with a brush or with a cloth. Remove
accumulated clipping deposits using a
stick. If necessary, use a special
cleaner (e.g. STIHL special cleaner).
● Never spray water or high pressure
cleaners onto switches, motor
components, seals or bearing points.
Cleaning position ME 443:
● Detach the grass catcher box. (Ö 8.3)
● Hold the upper handlebar (1) and open
the quick-clamping devices – fold
downwards.
● Set down the upper handlebar (1)
rearwards.
● Open the discharge flap (2) and hold it
open.
● Lift up the machine at the front and
place in the cleaning position as shown.
Check that the machine is stable.
Cleaning position ME 443 C:
● Detach the grass catcher box. (Ö 8.3)
● Open the discharge flap (2) and hold it
open.
● Press the detent lever (3) downwards
with the thumb and hold.
● Hold the machine at the front
handle and tilt it slowly rearwards.
● Release the discharge flap (2) and
check that the machine is standing
securely.
12.3 Electric motor and wheels
The electric motor is maintenance-free.
The wheel bearings are maintenance-free.
12.4 Upper handlebar ME 443
Maintenance interval:
Before each use
The upper handlebar is coated with a
insulating layer. Should this layer become
damaged, the upper handlebar must be
replaced.
12.5 Mowing blade maintenance
Maintenance interval:
Before each use
● Tilt the mower upwards into the
cleaning position. (Ö 12.2)
● Clean the mowing blade (1) and check
it for damage (notches or cracks) and
wear; replace if necessary.
● Use a slide calliper (not included in
standard equipment) to measure blade
thickness at 5 points at least. In
particular, the minimum thickness must
also be ensured in the area of the blade
wings.
● Place a ruler (2) against the front blade
edge and measure permissible
grinding.
12. Maintenance
Risk of injury!
Observe the safety instructions in
the section "For your safety" (Ö 4.).
15
16
Risk of injury!
Before tipping up the mower, place
it on firm, level and flat ground. The
machine may tip over when working
on it in the cleaning position.
Always stand to the side of the
machine. Never work in front of or
behind the mower.
To facilitate cleaning work, it is
recommended to select the highest
cutting level before placing the
machine in the cleaning position.
Danger of pinching!
After actuation of the detent lever,
the upper handlebar can fall to the
lowest position under its own
weight.
Never place your finger between
the handlebar and the handlebar
console (under the detent lever).
17
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking ME 443 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking ME 443 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 14,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info