667214

Viking ME 443 Manual

42
Zoom out
Zoom in
Previous page
1/250
Next page
0478 121 9920 D - EN
40
10.1 Safety devices
The lawn mower is equipped with safety
devices, which prevent inadvertent contact
with the mowing blade and with ejected
clippings.
These include the housing, discharge flap,
grass catcher box and correctly installed
handlebar.
10.2 Two-hand operation
The motor can only be switched on by
pressing and holding the ON button with
the right hand and then pulling the
motorstop lever to the handlebar with the
left hand.
10.3 Motor run-down brake
When the motorstop lever is released, the
mowing blade comes to a complete
standstill in less than three seconds.
An integrated motor run-down brake
shortens the run-down time until the blade
stops.
11.1 Electrical connection
Only electric cables which are no lighter
than rubber sheathed cables H07 RN-
F DIN/VDE 0282 may be used as electric
cables.
Recommended minimum cross-
section:
up to 25 m Length: 3 x 1.5 mm²
up to 50 m Length: 3 x 2.5 mm²
The connectors of the electric cable must
be made of rubber or have a rubber cover
and conform to the standard
DIN/VDE 0620.
The mains voltage and mains frequency
must correspond to the information on the
identification plate and the information
contained in the section
"Technical specifications" (Ö 18.).
The power cable must be adequately
protected by a fuse (Ö 18.).
This machine is intended for operation with
a power supply having a system
impedance of Z
max
at the transfer point
(house connection) of maximum
0.49 ohms (at 50 Hz).
The user must ensure that the machine is
only operated with a power supply which
meets this requirement. If necessary, this
information can be obtained from the local
electric power company.
11.2 Strain relief
During working, the strain relief
prevents any unintentional
disconnection of the electric cable and any
resulting damage to the mains connection
on the machine.
For this reason, the electric cable must be
fed through the strain relief.
● Form a loop in the power cable (1) and
guide it through the opening (2).
● Then push the loop over the hook (3)
and pull it tight.
11.3 Switching on the lawn
mower
● Press and hold down the ON button (1).
Pull motorstop lever (2) to handlebar
and hold.
● The ON button (1) can be released
once motorstop lever (2) is pressed.
11.4 Switching off lawn mower
● Release motorstop lever (1).
Motor and mowing blade come to
a stop after a short run-down time.
11.5 Emptying the grass catcher
box
● Detach the grass catcher box. (Ö 8.3)
● Open the grass catcher box at the
tab (1). Fold up the upper part of the
grass catcher box (2) and hold. Fold the
grass catcher box rearwards and empty
the clippings.
● Close the grass catcher box.
11. Operating the machine
Danger of electric shock!
Observe the safety instructions in
the section "For your safety" (Ö 4.).
If using a cable drum, the
connection cord must be unwound
completely, otherwise electrical
resistance may cause loss of power
and overheating.
11
Do not start the motor in high grass
or when the mower is set to the
lowest cutting height, as this makes
switching on difficult.
Risk of injury!
The motor must be stopped for
safety reasons before removing the
grass catcher box.
12
13
14
… 42 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking ME 443 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking ME 443 in the language / languages: English, German, Dutch, Danish, French, Italian, Portuguese, Swedish, Spanish, Norwegian as an attachment in your email.

The manual is 14,6 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info