667318

Viking MB 756 YS Manual

45
Zoom out
Zoom in
Previous page
1/234
Next page
43
DEFRNLITESPTPLHURU EN
0478 111 9925 B - EN
In order to prevent injuries or damage to
the machine, ensure that you are familiar
with operation of the BBC system prior to
initial use.
Two-hand operation:
The mowing blade can only be engaged as
follows with the engine running:
Press blade stop lever (1) towards the
handlebar and hold, then pull blade clutch
lever (2) upwards with the other hand and
allow it to engage.
Avoid overloading of the blade brake
clutch
An overload can occur
– if mowing is continued when the grass
catcher bag is full.
– if the mowing channel is blocked.
– if mowing at excessive speed in high
grass.
If the mowing blade is blocked, the grass is
no longer cut and the engine cuts out.
For this reason, never mow when the
mowing channel is blocked or the grass
catcher bag is full; adapt the driving speed
to the conditions. Use a mulching kit
(special accessory) if necessary.
Completion of work
Upon completing work, always remove
combustible material (grass, leaves, etc.)
from the housing and engine to prevent a
fire hazard.
A perfect, thick lawn is achieved by
– Mowing at low driving speeds.
– Mowing regularly and keeping the grass
short.
– Not cutting the lawn too short in hot, dry
conditions as it will be burnt by the sun
and become unsightly.
– Using a sharp mowing blade – mowing
blade should therefore be sharpened
regularly (specialist dealer).
– Changing the cutting direction regularly.
10.1 Starting the engine
● Check the oil and fuel levels.
(Ö 7.5)
● Open tank ventilation screw (1) and fuel
cock (2).
● Set throttle lever (3) to the
Choke position (4) when the
engine is cold.
Set throttle lever (3) to the Start
position (5) when the engine is
warm or during hot weather.
● Pull recoil starter rope (6) slowly to the
point of compression resistance and
then pull vigorously to arm's length to
prevent kickback.
Slowly release the cable so that it can
gradually be rolled up by the starter.
Repeat the starting procedure until the
engine starts.
● Set throttle lever (3) to the Start
position (5).
10.2 Engaging the mowing blade
● 1 Press blade stop lever (1) to the
handlebar and hold.
● 2 Pull blade clutch lever (2) back to
the stop and allow to engage.
● Keep blade stop lever (1) pressed when
working.
Risk of injury!
For safety reasons, the lever must
never be disabled, e.g. by tying it to
the handlebar.
Operation of the blade brake clutch
must be checked before each use.
(Ö 10.4)
Avoid damage to the machine!
Avoid overloading as this can result
in greater wear to the blade brake
clutch and consequently to
overheating. (Ö 9.)
9. Notes on working with the
machine
10. Operating the machine
Risk of injury!
Carefully read and observe the “For
your safety” section before
operating the machine. (Ö 4.)
11
Risk of injury!
If the recoil starter rope recoils at
high speed, the hand and arm will
be pulled towards the engine faster
than the cable can be released.
This can result in broken bones,
crush injuries and sprains.
Avoid damage to the machine!
Do not engage the mowing blade in
tall grass and only engage it at the
maximum engine speed.
Always engage it quickly in order to
prevent unnecessary wear to the
blade clutch.
12
… 45 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 756 YS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 756 YS in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 13,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info