667318

Viking MB 756 YS Manual

43
Zoom out
Zoom in
Previous page
1/234
Next page
41
DEFRNLITESPTPLHURU EN
0478 111 9925 B - EN
● Place the machine on level and firm
ground when performing all the
operations described.
7.1 Assembling the handlebar
MB 756.0 YC:
● 1 Remove screw (1) with
washer (2). Loosen screws (3).
● 2 Push handlebar (4) into handlebar
attachment (5) and fold up until the slot
in the handlebar is above the bore in the
housing, making sure that the cables
are lying correctly (see illustration).
● 3 Install screw (1) with washer (2),
making sure that the screw also
extends into guard plate (6).
● 4 Tighten screws (3) to 21 - 29 Nm.
Set the handlebar to the desired
working height and hold, tighten
screw (1).
● Check correct assembly:
The handlebar must be firmly located
with the cables to the rear and outside
of the handlebar.
MB 756.0 GS, MB 756.0 YS:
● 1 Guide upper handlebar (1)
with the open ends into lower
handlebars (2) and hold. Insert
bolts (G) from the outside inwards
through the bores, fit lock nuts (H) and
tighten to 19 - 27 Nm.
● 2 Set the handlebar to the desired
working height and hold, tighten
screw (3).
● Check correct assembly:
The upper handlebar must be firmly
connected to the lower handlebar with
the cables to the rear and outside of the
handlebar.
7.2 Installing protective sleeve
● Insert all cables in protective
sleeve (F).
● Guide cable tie (E) through the top
opening in right lower handlebar (1) and
use to fasten protective sleeve (F).
● Fasten protective sleeve (F) to right
upper handlebar with cable tie (E) as
shown.
7.3 Single-wheel cutting height
adjustment
The cutting height can be adjusted
to six different positions at each wheel
using a corresponding lever.
Lowest cutting height (1): 25 mm
Highest cutting height (6): 90 mm
Setting the cutting height:
● Push lever (1) towards the wheel, set to
the desired position and allow to
engage in the corresponding notch.
Stop position
Start the engine, engage the mowing
blade.
Disengage the mowing blade.
Switch on self-propulsion.
6. Standard equipment
Item Designation Qty.
A Basic unit with handlebar 1
B Grass catcher bag frame 1
C Grass catcher bag fabric 1
D Grass catcher bag flap 1
E Cable tie 2
F Protective sleeve 1
− Instruction manual 1
2
− Engine instruction manual 1
MB 756.0 GS, MB 756.0 YS:
G Flat head bolt 4
H Lock nut 4
7. Preparing the machine for
operation
Risk of injury:
Observe the safety instructions in
the section "For your safety" (Ö 4.).
Item Designation Qty.
3
4
5
6
… 43 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 756 YS at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 756 YS in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 13,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info