667223
38
Zoom out
Zoom in
Previous page
1/269
Next page
0478 111 9922 B - EN
36
Lift grass catcher box (2) and remove
rearwards.
Slowly close the discharge flap (1).
7.7 Central cutting height
adjustment
Seven different cutting heights between
25 mm and 75 mm can be set.
Cutting level 1:
Lowest cutting height
Cutting level 7:
Highest cutting height
Press the cutting height adjustment
lever (1) to the rear wheel (2) with one
hand and hold in position.
Set the cutting height adjustment
lever (1) to the required position.
Slowly release the cutting height
adjustment lever (1) again and allow it
to engage.
7.8 Fuel and engine oil
Engine oil:
Please consult the engine
instruction manual for the type of
engine oil to be used and the oil capacity.
Check the oil filling level at regular
intervals (see engine instruction manual).
Avoid exceeding or falling below the
correct oil level.
Fuel:
Recommendation:
Fresh good quality fuel.
Please consult the engine
instruction manual for details on the fuel
quality (octane rating).
Unleaded petrol
A funnel should be used when filling the
tank with fuel (not included in standard
equipment).
The machine is equipped with several
safety devices for safe operation and for
the prevention of improper use.
8.1 Safety devices
The lawn mower is equipped with safety
devices, which prevent inadvertent contact
with the mowing blade and with ejected
clippings.
These include the housing, discharge flap,
grass catcher box and correctly-installed
handlebar.
8.2 Motorstop lever
The lawn mower is equipped with a
motorstop device.
The engine stops when the motorstop
lever is released during running operation.
The engine and blade come to a standstill
within 3 seconds.
Measuring the run-on time
Following engine start-up, the blade
rotates and a wind noise is audible. The
run-on time corresponds to the duration of
the wind noise after the engine stops. This
can be measured using a stopwatch.
A perfect, thick lawn is achieved by
Mowing at low driving speeds.
Mowing regularly and keeping the grass
short.
Not cutting the lawn too short in hot, dry
conditions as it will be burnt by the sun
and become unsightly.
Using a sharp mowing blade – mowing
blade should therefore be sharpened
regularly (specialist dealer).
Changing the cutting direction regularly.
Risk of injury!
Stop the engine before adjusting
the cutting height.
Risk of injury!
Note the warnings in the section
"For your safety". (Ö 4.)
Avoid damage to the machine.
Top up the engine oil before starting
for the first time (see engine
instruction manual). VIKING
recommends using a suitable filling
aid when topping up the engine oil
(e.g. funnel). The filling aid is not
included in the standard equipment.
7
8
8. Safety devices
Risk of injury
If a safety device is found to be
defective, the machine must not be
operated. Consult a specialist
dealer; VIKING recommends
VIKING specialist dealers.
Risk of injury!
If the run-on time of the blade
exceeds this delay, stop using the
machine and take it to your
specialist dealer.
9. Notes on working with the
machine
38


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Viking MB 248T at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Viking MB 248T in the language / languages: All languages as an attachment in your email.

The manual is 11,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info