806448
51
Zoom out
Zoom in
Previous page
1/116
Next page
51
EN
Follow the steps below to remove frost build-up:
6. TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTIONS
The appliance
does not cool
at all
-The temperature control knob is
positioned wrong.
-The plug is not inserted properly.
-There is no voltage on the
socket.
-The fuse is blown or defective.
-The appliance is installed in
a place where the ambient
temperature is less than 10°C,
such as a balcony, garage or
storage room.
-Switch the thermostat to
another position.
-Insert the plug properly.
-Open the door and check
if lamp is on. If the lamp
is off, there may be no
voltage on the socket. Have
the socket repaired by an
electrician.
-Check the fuse and replace
if necessary.
-Install the appliance in a
protected location where
the ambient temperature
is higher than 10°C. If
the appliance is installed
in a room with too low a
temperature, the internal
cooling system may not
operate correctly.
The door does
not open
easily.
-You tried to open the door
immediately after closing. -Wait a few seconds
between closing and re-
opening the door.
Water runs
over the
back of the
appliance
-During the automatic defrosting
process, icing thaws against the
back wall.
-Wipe up the water with a
soft cloth.
You can solve some problems easily yourself using the table below. Caution!
Before solving the problem, switch off the power supply.
If the following descriptions do not solve your problem, please contact
our customer service: www.coolblue.nl/en/customer-service
Only a qualied electrician or authorised person may solve the faults
not contained in this manual. Repairs carried out by unauthorised
persons may cause injury and/or serious damage to persons and
property.
ATTENTION!
!
51


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Veripart VPTMVR85 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Veripart VPTMVR85 in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 1.48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info