488163

Venga VG SIS 2 Manual

13
Zoom out
Zoom in
Previous page
1/56
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
13
VG SIS 2 - 101214
Assembly page 13/56
Fax +32 2 359 95 50
STEAM-IRONING
• Fill the water tank with water and insert the mains plug into a wall socket.
• As indicated on the temperature dial (5) and in the table, steam ironing is only possible at
higher ironing temperatures, so set the dial to  or .
• Put the switch (1) in ON position ("1") and set the temperature dial of the iron (5) to the
desired position. When the iron has reached the desired temperature, its pilot light (8) will
go out. You can now use the steam function.
• Turn the steam control knob (12) to regulate the amount of steam. Note: the maximal
steam rate (“MAX”) can only be used when the ironing temperature is higher than position
, or else water will drip from the sole.
• Press the steam button (6) to release steam from the soleplate of the iron. Release the
button and the steam will stop. If you want a continuous jet of steam, press the steam
button down and slide its transparent top part backwards so that the steam button locks.
To stop the continuous jet of steam, push the transparent part of the button forwards
again and release the steam button.
• When ironing, the pilot light of the iron (8) will go on and off from time to time. This means
that the temperature of the iron is regulated by its thermostat. You can continue ironing.
The pump pilot light will also go on and off, indicating that the steam pressure is being
regulated.
• When you use a lot of steam in a very short time, the steam output is lightly reduced until
your appliance produces enough steam to reduce the difference. This phenomenon also
happens when there isn’t enough water in the water tank.
• When the water tank is running empty, you will hear more noise when pressing the steam
button. If you want to go on using the steam function, you will have to refill the water tank.
STEAMING IN A VERTICAL POSITION
Position the temperature dial on its maximum level for vertical steam ironing. The steam rate
can be adjusted according to your needs.
You have to hang the cloth you want to smooth out avoiding the creases and place the iron in
a vertical position at a few centimetres from the piece of cloth. Then move the iron and press
the burst of steam button at the same time.
DRY IRONING
• Plug in the appliance and switch it on (power switch in position “I”).
• Use the temperature dial to set the temperature needed.
• When the indicator lamp of the iron goes out for the second time, you can start ironing.
• For ironing without steam, leave the steam control knob in OFF position and do not press
the steam button (6).
WHEN FINISHED IRONING
• We recommend cleaning the iron after use as follows: fill the water tank, put the
temperature dial on position “LINEN” and the steam regulator on MAX and let the iron
heat for 10 minutes. When the temperature has been reached, take the iron from the
base, hold it vertically and keep the steam button pressed for 30 seconds, then wait 30
seconds and repeat this cycle twice.
• Switch off the appliance (power switch in position “0”), unplug the appliance and let it
cool down.
• Empty the water tank.
• We recommend placing the iron on its base when you store it. The therefore foreseen
place is non-slip and will not damage the soleplate of the iron.
… 13 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Venga VG SIS 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Venga VG SIS 2 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info