488163

Venga VG SIS 2 Manual

12
Zoom out
Zoom in
Previous page
1/56
Next page
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Team
International BELGIUM. The pages must be reproduced
and folded in order to obtain a booklet A5 (+/- 148.5 mm
width x 210 mm height). When folding, make sure you
keep the good numbering when you turn the pages of
the I/B. Don’t change the page numbering. Keep the
language integrity.
12
VG SIS 2 - 101214
Assembly page 12/56
Fax +32 2 359 95 50
• Plug in the appliance and put the switch (1) in position “I” to switch it on. The power light
of the switch (1) and the pump pilot light (2) will light up, indicating that the appliance is
working and the iron is heating. Set the temperature dial of the iron (5) to the desired
position, the indicator lamp of the iron (8) will light up. As soon as the desired temperature
is reached, the pilot light of the iron will go out and you can start ironing.
• During ironing this pilot light (8) will come on from time to time. When this happens, the
soleplate is being heated up to the required temperature again. You can continue
ironing.
• The table is valid for the fibre materials only. If some kind of finish has been applied (gloss,
wrinkle, relief etc), the textile can best be ironed at a lower temperature.
First sort out the fabrics according to ironing temperature: wool with wool, cotton with
cotton, etc.
• The iron heats up quicker than it cools down. Therefore, start ironing the articles requiring
the lowest temperature such as those made of synthetic fibres. Then progress to the higher
temperatures.
• If the article is made of a mixture of different fibres, you must always select the lowest
ironing temperature of the composition of those fibres.
(E.g. an article consisting of “60% polyester and 40% cotton” should be ironed at the
temperature indicated for polyester and without steam.)
If you do not know what kind(s) of fabric(s) the article has been made of, find a spot,
which will be invisible when wearing or using the article to try out the ironing temperature.
(Always start at a low temperature and increase to one which gives the required results.)
• Pure woollen fabrics (100% wool) may be pressed with the iron set to a steam position. It is
recommended to apply shot-of-steam and use a dry pressing cloth.
When steam-ironing woollen fabrics, shining of the fabric may occur. This can be
prevented by turning the article inside out and ironing the inside or by interposing a light
damp cloth.
• Velvet and other textures that rapidly acquire shiny spots should be ironed in one direction
only (with the nap), applying only light pressure.
Always keep the iron moving.
• Iron the reverse side of synthetic materials and silk, it is not advisable to use steam as this
may cause stains.
FILLING WITH WATER (FOR STEAM-IRONING)
1. Put the base on a stable surface.
2. Use the small grips (4) of the water tank to take out the water tank. Open the cap (7) and
fill the water tank with clear water up to its "Max" level. Do not fill beyond this maximum
level! You can use tap water, but we advise you to use distilled water.
3. Close the cap (7) of the water tank.
4. Put the water tank back in the base correctly. Make sure to keep it upright in order to
avoid spilling water. Press the grips until the water tank is locked in place.
5. Never use vinegar, detergents or other chemical products.
FILLING THE WATER TANK DURING USE
As the water tank of this appliance is not under pressure, you can refill it during use. To do so,
switch off the appliance, unplug it and just proceed as described above in the "Filling with
water" section. When you have put the water tank back in place, plug the appliance in again,
switch it on and wait until the indicator lamp of the iron goes out. Then you can start ironing
again.
… 12 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Venga VG SIS 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Venga VG SIS 2 in the language / languages: English, German, Dutch, French, Italian, Polish, Portuguese, Spanish as an attachment in your email.

The manual is 1,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info