7
Vasa Ergometer User’s Manual
07/01/11
U-BOLT
slide the bracket on to the REAR of the monorail.
NOTE: The U-bolt is closer to front
loosen the socket set screw
STEP 4: MONORAIL INTO THE REAR STANCHION ASSEMBLY
4.1. Loosen the socket set screw on the corner of the rear stanchion head (Figure A) using the 3/16” hex key
Allen wrench.
4.2. Hold the rear stanchion assembly upside down and slide the bracket over the rear section of the
monorail (Figure B).
4.3 Align the holes and insert a 2 1/2” button head screw through bracket and monorail. Thread the hex jam
nut on the end of bolt. Tighten to secure with a 5/32” Allen wrench and 7/16” wrench (Figure C).
4.4 Tighten the socket set screw against monorail using the 3/16” hex key Allen wrench. This will secure
the monorail to the inside of the sleeve so that it won’t loosen or rattle while in use (Figure C).
$I¿[DWHWKHUFRUGWRWKHUHDUVWDQFKLRQ'ULQJDQGWKH8EROWRQWKHVHDWFDUULDJH)LJXUH'
attach cord
REAR FRONT
REAR STANCHION
ASSEMBLY
Figure A
Figure C
Figure B
Figure D
1. insert and tighten 2 1/2” button head
screw and hex jam nut.
2. tighten socket set screw with 3/16” hex
key wrench
attach the tether cord to the seat carriage U-bolt and
the rear stanchion D-ring
PART 1 - Assembly
