611085
8
Zoom out
Zoom in
Previous page
1/20
Next page
8
7. APPLIANCE
PRE-INSTALLATION
PREPARATION
7.1 Check ignition spark
Before attempting to install, it is worth checking that
the electronic ignition system performs satisfactorily.
7.1.1 Fit the battery to the ignition block located below
the burner tray at the left side (see figure 5).
7.1.2 Rotate the control pivot bracket clockwise as far as it
will go (see figure 6). This should close the ignition
circuit.
Sparks should be seen tracking from the electrode
pin to the thermocouple tip (see figure 7).
If there are no sparks make the following checks.
a) Check condition of battery and that it is
correctly fitted.
b) Check spark gap between electrode wire and
thermocouple tip (see figure 7).
c) If a & b are satisfactory, check the ignition
circuit and components.
7.2 Detach the gas valve and connector unit from the
regulator inlet pipe (see figure 8). Keep the unit
safe.
7.3 Detach the burner unit from the convection box by
removing three screws (see figure 9). Lift out the
burner unit.
Fig. 5 Battery location
Fig. 6 Control pivot rotation
Fig.7. Pilot ignition unit
Fig. 9 Burner attachment points
Fig. 8 Gas valve unit disconnection
8


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Valor 722AN at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Valor 722AN in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info