652332
14
Zoom out
Zoom in
Previous page
1/36
Next page
14
Installation info
fig. 9
2.2.2 - POSITIONING THE BOILER
Every boiler is supplied with special “MOUNT-
ING JIG” with which the pipes for connection
to the system, D.H.W. and gas can be
positioned when the hydraulic system is being
laid out and before the boiler is installed.
This MOUNTING JIG, comprising a sheet of
strong paper which must be fixed to the wall
chosen for the installation of the boiler, gives
all the indications needed to make the holes
in the wall using two screws with expanding
dowels.
Use the lower part of the MOUNTING JIG to
mark the exact point of the connection of the
gas supply, cold water supply pipe, D.H.W.
outlet, C.H. flow and return.
When choosing the position of the boiler:
- refer to the indications given in the section
“Flue gas evacuation system “.
- leave a clearance of 50 mm on each side
of the boiler to facilitate maintenance ope-
rations.
- Leave a 200 mm free space under the boi-
ler in order to allow the possible verifica-
tion or substitution of the DHW plates heat
exchanger.
- check that the wall is suitable.
- avoid fixing the boiler to thin partitions.
- avoid installing the boiler above applian-
ces which might affect operation when in
use (cookers which produce greasy
steam, washing machines, etc.)
- avoid installing natural draught boilers in
corrosive or very dusty atmospheres such
as hairdressers’, laundrettes, etc. as the
life of the boiler components could be si-
gnificantly shortened.
M = C.H. system
flow
C = D.H.W.
outlet
G = Gas
F = Cold water
inlet
R = C.H. system
return
Vs = Safety valve
discharge
Si = Boiler drain cock
ØL mm
= 3/4'' 107
= 1/2'' 107
= 3/4'' 107
= 1/2'' 107
= 3/4'' 107
= 143
=60
For EVE 05 TFS
Since the temperature of the wall
on which the boiler is installed
and the temperature on the sur-
face of the coaxial duct do not increase, in
normal operating conditions, more than 60 K,
it is not necessary to keep a minimum distan-
ce from inflammable walls.
For boilers with dual suction and exhaust ducts,
place insulating material between the wall and
the pipe in the case of inflammable walls and
wall crossings.
87 120
78.5
110
139
182
CF G R M
10
56 60
51
79
70
752
00332145
143
34
14.5
420
CONNECTION POSITION SEEN FROM BELOW
MOUNTING JIG FOR BOILER CONNECTIONS 00332145
EVE 05 TN
Maintain distance of at least 200
mm on the sides with wall which
have inflammable materials.
107
290
CF
G
R
M
Rc
Vs
Si
143
60
360 60
130
14


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Unical EVE 05 RTFS 24 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Unical EVE 05 RTFS 24 in the language / languages: English as an attachment in your email.

The manual is 1,36 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info