647781
10
Zoom out
Zoom in
Previous page
1/63
Next page
10 GB/IE/NI
Operation Safety notices / Operation
member standby operation also
consumes electricity.
Always be alert and always be
careful what you do. Always
proceed with caution and do not
operate the car charger when
unfocused or feel unwell.
Operation
Remove the mains plug from the mains socket before
performing any work on the car charger.
RISK OF ELECTRIC SHOCK!
DANGER OF DAMAGE TO PROPERTY!
RISK OF INJURY!
Product properties
This device is designed to charge a variety of SLA
batteries (sealed lead-acid batteries) primarily used
in cars, motorcycles and some other vehicles. These
can be e.g. WET- (with liquid electrolyte), GEL- (with
gelified electrolyte) or AGM batteries (with electrolyte
absorbent glass mat). The special design of the device
(also referred to as “three-level charging strategy“)
allows the battery to be charged to nearly 100 %
of
its capacity. The charger can further be connected
to the battery for extended periods to keep it in op-
timal condition.
Connecting
Before charging and trickle charging a battery
permanently connected to the vehicle, first dis-
connect the battery‘s negative terminal connec-
tion cable (black) from the negative battery
terminal. The negative battery terminal is typi-
cally connected to the car body.
Then disconnect the vehicle‘s positive terminal
connection cable (red) from the positive battery
terminal.
Only then connect the battery charger‘s “+“
crocodile clamp (red)
7
to the “+“ battery
terminal.
Connect the “-“ crocodile clamp (black)
6
to
the “–“ battery terminal. Plug the car charger‘s
mains cable
9
into the mains socket.
Note: If the connector clamps are correctly conn
ected,
the display will show the voltage and “connected“
will light up. If the poles are reversed, the display
will read 0.0 and “connected“ will not light up.
Disconnecting
Disconnect the device from the mains.
Remove the “–“ crocodile clamp (black)
6
from
the “–“ battery terminal.
Remove the “+“ crocodile clamp (red)
7
from
the “+“ battery terminal.
Reconnect the vehicle‘s positive connection cable
to the positive battery terminal.
R
econnect the vehicle‘s negative connection cab
le
to the negative battery terminal.
Selecting the charging mode
You can charge a variety of batteries at different
ambient temperatures using different charging mo
des.
Compared to conventional car chargers, this device
features a special function for reusing a drained bat-
tery / rechargeable battery. You can recharge a
completely drained battery / rechargeable battery.
The safe charging process protects against faulty co
n-
nection and short-circuits. The integrated electronics
do not switch the car charger on immediately after
being connected, but only after selecting a charging
mode.
If the connector clamps connected to the battery
and the device is connected to power, the digital
display
10
will read “Connected“. After selecting a
charging mode, the display will read “Charging“.
Once charging is complete, the display will read
“Charged“.
A continuously lit display with the battery not yet fully
charged indicate a fault.
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ultimate speed ULG 12 A2 - IAN 277071 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ultimate speed ULG 12 A2 - IAN 277071 in the language / languages: English, German, Dutch, Danish, French as an attachment in your email.

The manual is 0,78 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info