INSTALLATION
・ Charge the battery for 4-5 hours with the charger until four bars light up
in the charging status display. Always fully charge the device before using
it for the first time and after a long period of non-use. Then pull out the
mains plug.
・ If the cyclone insert with HEPA filter is in the motor unit and installed
together with the dust container, you can start up the vacuum cleaner.
・ Mount the suction pipe or the appropriate nozzle or brush as described.
・ Press the ON / OFF button ⑵ to switch on the vacuum cleaner.
・ With the suction power button (1) you can set the suction power: high or
low.
・ If you want to change the nozzles or brushes, always switch off the
device with the ON/OFF button.
EMPTY DUST CONTAINER
・ When the dust container is full, you should empty it to maintain full
suction power.
・ The device must be switched off beforehand and the battery removed
from the motor unit (press the release button (14)) before emptying the
dust container.
1. Turn the dust container to separate it from the motor unit.
2. Hold the flap of the dust container over a waste bin and press the button
(10) to open the flap. Empty dust and dirt.
3. Close the flap again so that it clicks into place. Put the empty dust
container back into the device.
CLEANING THE DUST CONTAINER, THE CYCLONE
INSERT AND THE FILTER
From time to time you should remove and clean the dust container and the
cyclone insert with HEPA filter, at the latest when you notice that the suction
power is deteriorating. Switch off the device with the ON / OFF button and
remove the battery.
1. Turn the dust container (8) and remove it from the device. Empty it as
described in the chapter "Emptying the dust container".
2. Take the cyclone insert and the HEPA filter out of the dust container.
3. Knock out the cyclone insert and the HEPA filter or clean them with a
brush.
