Manual Trumatic C 6002 EH (page 14 of 56) (English, German, Dutch, Danish, French, Italian, Spanish)

484640

Zoom out

Zoom in

1/56

1. Case of warranty

The manufacturer grants a

warranty for malfunctions

in the appliance which are

based on material or produc-

tion faults. In addition to this,

the statutory warranty claims

against the seller remain

valid.

A claim under warranty shall

not pertain:

– for parts subject to wear

and in cases of natural

wear and tear,

– as a result of using com-

ponents in the units that

are not original Truma parts

and using unsuitable gas

pressure regulators,

– as a consequence of failure

to respect Truma instruc-

tions for installation and

use,

– as a consequence of

improper handling,

– as a consequence of im-

proper transport packing,

not arranged by Truma.

2. Scope of warranty

The warranty is valid for

malfunctions as stated under

item 1, which occur within

24 months after conclusion

of the purchase agreement

between the seller and the

final consumer. The manufac-

turers will make good such

defects by subsequent fulfil-

ment, i.e. at their discretion

either by repair or replace-

ment. In the event of manu-

facturers providing service

under warranty, the term

of the warranty shall not re-

commence anew with regard

to the repaired or replaced

parts; rather, the old warranty

period shall continue to run.

More extensive claims, in

particular claims for compen-

satory damages by purchas-

ers or third parties, shall

be excluded. This does not

affect the rules of the product

liability law.

The manufacturer shall bear

the cost of employing the

Truma customer service for

the removal of a malfunction

under warranty – in par-

ticular transportation costs,

travelling expenses, job and

material costs, as long as the

service is carried out in Ger-

many. The warranty does not

cover customer service work

in other countries.

Additional costs based on

complicated removal and

installation conditions of the

appliance (e.g. removal of

furniture or parts of the vehi-

cle body) do not come under

warranty.

3. Raising the case of

warranty

The manufacturer's address

is:

Truma Gerätetechnik

GmbH & Co. KG,

Wernher-von-Braun Straße 12,

85640 Putzbrunn.

In Germany, always notify

the Truma service centre if

problems are encountered; in

other countries the relevant

service partners should be

contacted (see list of ad-

dresses). Any complaints are

to be described in detail. In

addition, the properly com-

pleted guarantee certificate

is to be presented, or the fac-

tory number of the unit and

the date of purchase given.

In order for the manufactur-

ers to be able to determine

whether an incident subject

to guarantee has occurred,

the end user must, at his own

risk, bring the device to the

manufacturers or send it to

them. If there is damage to

heaters (heat exchangers),

the gas pressure regulator

must also be sent back to the

factory.

In instances of the device

being sent to the works,

dispatch is to be effected by

freight transport. In cases

under guarantee, the works

shall bear the transport costs

or the costs of delivery and

return. If the damage is

deemed not to be a warranty

case, the manufacturer shall

notify the customer and shall

specify repair costs which

shall not be borne by the

manufacturer; in this case,

the customer shall also bear

the shipping costs.

Technical data

termined in accordance with EN 624 or Truma test conditions

Type of gas:

Liquid gas (propane/butane)

Operating pressure:

30 mbar

Water contents:

12 litres

Heating up time from approx. 15°C to approx. 60°C:

Summer-/gas operation: approx. 30 minutes

(measured according to

EN 15033)

Summer-/electrical operation (1800 W): approx. 45 min.

Winter mode: approx. 60 min. upward

(depending on the heat output)

Water pressure:

max. 2.8 bar

Rated thermal output:

Liquid gas: 2000 W, 4000 W, 6000 W

Electrical: 900 W, 1800 W

Gas consumption:

170 – 480 g/h

Air delivery volume:

max. 287 m³/h (free-blowing without warm-air duct)

Current input at 12 V:

Heater + water heater: 0.2 – 5.6 A

Heating up of water heater: 0.4 A

Stand-by: 0.001 A

Current input of electrical safety/drain valve at 12 V:

0.035 A

Current input of 230 V:

900 W (3.9 A) or 1800 W (7.8 A)

Weight:

approx. 18.7 kg (without water contents)

Declaration of conformity :

The Trumatic C 6002 EH has been tested by the DVGW and

complies with the gas equipment directive (90/396/EEC) and

the other applicable EC directives. The following CE Product

Ident. No. is available for EU countries:

CE-0085AS0122.

The heater complies with heater directive 2001/56/EC and supple-

ments 2004/78/EC and 2006/119/EC and bears the type approval

number:

e1 00 0146.

The heater complies with vehicle engine interference suppres-

sion directive 72/245/EEC with supplements 2004/104/EC and

2005/83/EC, and bears type approval number:

e1 03 2499.

The heater complies with EMC directive 89/336/EEC and low

voltage directive 73/23/EEC.

The right to effect technical modifications is reserved!

Manufacturer´s terms of warranty

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Trumatic C 6002 EH in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,77 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Trumatic C 6002 EH Manual

Product: