484640
15
Zoom out
Zoom in
Previous page
1/56
Next page
15
Gas operation
No control lamp lights
up when the system is
switched on (winter and
summer mode).
The green indicator lamp
comes on when the equip-
ment is switched on, but
the heater is not operating.
The red monitor lamp flash-
es after the heating system
has been switched on.
About 30 seconds after the
heating has been switched
on, the red monitor lamp
lights up and remains
steady.
Heating switches to fault
mode after an extended
period of operation.
Electrical
operation 230 V
The green indicator lamp
on the control panel illu-
minates when the unit is
switched on, the yellow in-
dicator lamp on the power
selector switch does not
illuminate and the heating
does not become warm.
Water supply
When the heating system
is switched off, the elec-
trical safety/drain valve
opens.
The valve remains open
even after the heating
has been switched on.
The electrical safety/drain
valve will no longer close.
The valve remains open
even after the heating
has been switched on.
Water dripping from the
electrical safety/drain valve.
No supply voltage.
Device fuse or vehicle fuse
defective.
The temperature setting on
the control panel is lower
than the room temperature.
Open window above cowl
(window switch).
Battery voltage is too low
< 10.5 V.
Gas cylinder or quick-clo-
sure valve in the gas line is
closed.
Air feed interrupted.
Hot-air outlets blocked.
Gas pressure regulator
iced up.
Butane content in the gas
cylinder too high.
No supply voltage.
Device fuse defective.
Overheating switch has
triggered.
Outside temperature below
4°C.
No 12 V power supply at
the drain valve.
Outside temperature below
8°C.
No 12 V power supply at
the drain valve.
Water pressure too high.
Check battery voltage (12 V).
Check all electrical plug connections.
Check device fuse (see Maintenance).
– Check vehicle fuse.
Select higher room temperature at the control panel.
– Close window.
– Charge battery.
– Check gas feed.
Check cowl for possible coverage.
If being used on boats, open the deck cowl.
Check individual outlet apertures.
Use de-icing system controller (EisEx).
Use propane (at temperatures below 10°C in particular,
butane is unsuitable for heating purposes).
Check 230 V supply voltage and fuses.
Check device fuse (see Maintenance).
Reset overheating switch (see Maintenance).
Switch the heating on (at temperatures of about 4°C and
below the drain valve will open automatically).
Check 12 V supply voltage and fuses.
Switch the heating on (without heating operation, the drain
valve will not close again until temperatures above 8°C have
been reached).
Check 12 V supply voltage and fuses.
Check pump pressure (max. 2.8 bar).
If connected to a central water supply (rural or urban
connection), a pressure reducer must be used, which will
prevent pressures higher than 2.8 bar entering the boiler.
Trouble-shooting list
Fault Cause Rectification
If these measures do not lead to the rectification of the fault, in principle we would ask you to contact
Truma After-Sales Service.
15


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trumatic C 6002 EH at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trumatic C 6002 EH in the language / languages: English, German, Dutch, Danish, French, Italian, Spanish as an attachment in your email.

The manual is 1,77 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info