Manual Truma Ultrastore Rapid GE (page 9 of 16) (English)

631208

Zoom out

Zoom in

1/16

Choice of location

Always install the appliance in such a way that it is easily

accessible for service work at all times and can be easily

removed and installed.

Locate the heater in such a way that the cowl can be mounted

on the outside on a surface which is as straight and smooth

as possible. This outside surface must be exposed to wind

from all directions and, if possible, there should be no trim

strips or covers in this area, mount heater on an appropriate

base, if necessary.

The cowl may not be positioned within 500 mm (A) of a refu-

elling point or fuel tank breather outlet or within 300 mm (A)

of a ventilator for the living space. If the cowl is positioned

vertically below an opening part of a window, the water heater

must be fitted with an automatic shut-off device (please refer

to page 14) to prevent operation when the window is open.

Window

Floor

300 mm

Prohibited

Zone

Prohibited

Zone

The heater must not be installed close to or directly behind a

room / space heater.

To achieve reasonable air flow for electronics cooling,

there should be a minimum distance of 20 mm between the

electronics cover (34) and the walls of the furniture piece

the Ultrastore is located in.

Installation of the water heater

Position template for cowl opening on the inside of the wall.

A = bottom edge of heater

B = lateral edge of heater

Drill 4 holes (C) with 10 mm dia. through the wall. Drill hole (E)

with 15 mm dia. for condensation pipe (also possible from the

outside = F).

Position template on the outside of the wall. The markings (C)

must be above the through-holes. Saw cut-out section for

cowl (D) 92 x 168 mm.

If the distance between outside wall and heater is more than

35 mm you must use the cowl extension VBO 2 (please refer

to page 14) with an additional length of 50 mm. Saw out

100 x 176 mm along the dashed line.

rea cut-away

for clarification

If there are any cavities in

the area of the cowl, pack

these with pieces of wood

so as to be able to tighten

the screws. The finished

hole should be 168 mm high

and 92 mm wide.

Cut out trim strips or such on the vehicle or place supports

beneath them so as to make the cowl lie flat.

Place a support beneath the heater if the walls are sloping.

An angle of inclination of 10 degrees is not to be exceeded.

Installation instructions

Installation and repair are only to be carried out by an

expert. Always read and follow the operating instructions

carefully prior to starting any work!

Non-compliance with installation instructions or

incorrect installation can result in endangerment

of persons and property.

Intended use

This appliance has been designed for the installation in cara-

vans, motor homes and other vehicles. It is not approved

for installation in boats. Other forms of use are also possible

following consultation with Truma.

Information regarding boats: For installation in boats Truma

supplies the DVGW-tested boat water heater.

Regulations

Any modifications to the unit (including the exhaust duct and

the cowl) or the use of spare parts and accessories that are

important to the operation of the system (e.g. the time switch)

that are not original Truma parts and failure to follow the in-

stallation and operating instructions will cancel the warranty

and indemnify Truma from any liability claims. It also becomes

illegal to use the appliance, and in some countries this even

makes it illegal to use the vehicle.

In-vehicle installations must comply with the technical and

administrative regulations of the respective country of use

(e.g. EN 1949 for vehicles). The national regulations and rules

must be complied with.

Water heater kit

The water heater kit contains

1 Assembled water heater

1 Cowl assembly with screws

1 Hot water connector

1 Cold water connector

1 Safety (pressure relief) drain valve

1 Wall switch (gas operation) with 3 m cable

1 Wall switch (230 V operation)

1 Installation template

1 Set literature

1 Label with warning information

In order to guarantee complete emptying of the water con-

tent, ongoing sealing tightness of the water connections and

safety function all enclosed parts must be used!

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Truma Ultrastore Rapid GE in the language / languages: English as an attachment in your email.

The manual is 1,38 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Truma Ultrastore Rapid GE Manual

Product: