9
Installation and repairs
may only be carried out by
qualified personnel! Read
the installation instructions
carefully before starting work,
and follow them closely.
Important installation
instructions
1. The screened measuring
cable (length 6 m) must not
be shortened, lengthened, or
kinked!
2. If an aperture (5) needs to
be drilled from the gas cylin-
der container directly into the
interior of the vehicle, in
order for the cable to be laid
satisfactorily, this aperture
must be located at least
50 cm above the base, and
then sealed with silicone or
a similar material.
3. In order to avoid faulty
measurements, the measure-
ment cables (4) (including the
cable of the Sonatic L) must
be laid at a distance of at
least 20 cm from the electric
leads (for halogen lights in
particular).
4. Standing on the mount will
cause the gas cylinder to be
raised up by about 20 mm. If
necessary, the securing arran-
gement for the cylinder will
need to be adjusted by the
appropriate means in order
for the cylinder to be secured
in the specified manner!
Installing the gas
cylinder mount
Fig. A: Release the gas cylin-
der securing device and lay
the mount (1) beneath the
cylinder in such a way that
the measuring cable (2) can
be guided out of the cylinder
container at a protected
point. Secure the cylinder
once again, so as to ensure
that it is set vertical on the
cylinder mount.
Mark the four securing points
or the contour line, and take
the mount out again.
Drill four securing holes (take
care to avoid any cables, gas
pipes, etc. which may be
located beneath), and secure
the measuring plates with
four screws (Fig. A: 3 - not
included in scope of supply;
the type and length of the
screws are to be selected to
suit the condition of the
base).
Place the gas cylinder in po-
sition, and secure it again in
the specified manner.
Note: To avoid faulty measu-
rements, the mount must be
positioned horizontally in the
vehicle.
If a horizontal securing strap
is not going to be used any
longer, a vertical tensioning
strap must be fitted beneath
the mount (available from
specialist dealers - see Fig. A
- left-hand gas cylinder).
Electrical connection
Fig. A: The measuring cable
(2 - length 6 m) is laid through
cut-outs in the base area of
the gas cylinder container (4),
along the gas pipe, free of
any kinks, to the location cho-
sen for the operating section.
In order to avoid any dama-
ge, the measurement cable
can be laid in a protective
duct (internal diameter
15 mm) in the area of the
cylinder mount.
Drill a hole with a diameter of
15 mm to feed the measuring
cable into the interior of the
vehicle, and lay the connec-
tion cable to the location in-
tended for the operating sec-
tion.
Fig. B: Drill a hole with a dia-
meter of 15 mm (6) to feed
the cable through at the loca-
tion chosen for the operating
section.
Feed the measuring cable
and 12 V power feed from in-
side the vehicle through the
wall, and connect them to
the operating section in ac-
cordance with the connection
diagram (Fig. C).
Secure the operating section
with the two recessed head
screws provided.
For „flush-fitted“ installation
of the operating section,
Truma can provide an opera-
ting section frame as a speci-
al accessory (Art. No. 39980-
01).
Connect the device to the
screened on-board network
(central 5-10 A electrical
supply) by means of a 2 x
0.75 mm
2
cable. If connec-
Installation
Instructions
