753335
9
Zoom out
Zoom in
Previous page
1/15
Next page
EN 9
engraving pen PEGS 10-230V
Stroke depth selection
Via the setting wheel(2) for the stroke depth selection, the
penetration depth and therefore the engraving depth is adjusted.
It is not intended to be an off-switch. The required stroke depth
depends on the material and the operating conditions and can
be determined by way of field-testing. To do this, ideally use
some excess material residues. As a rule of thumb, generally
the lowest setting can be selected. In most cases this supplies
engraving results of a sufficient depth.
You can change the stroke depth which you have preselected at
any time.
1. Turn the setting wheel(2) in + or - direction to increase or
reduce the stroke depth
2
Note
The setting wheel(2) has no locking point in +
direction. When setting the stroke depth, make sure
that you do not turn the setting wheel(2) too far in the
+ direction. Otherwise you may unscrew the setting
wheel(2) from the product.
Operation
Tips and notes for handling the engraving pen
Hold the device at a slight angle similar to the position of
holding a pen. Your arm should be resting on the table.
Guide the engraving bit (4) over the workpiece applying
slight pressure.
Preferably use excess material to test the feed rate.
Switching the device on and off
Wear your personal protective equipment when working with
the device.
1. Check whether the stroke depth set is suitable for the
intended application.
2. Press the on/off switch(1) and hold it during operation.
1
ðThe device operates with the previously selected
settings.
3. Let go of the on-/off-switch(1) to stop the device.
1
9


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Trotec PEGS 10-230V at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Trotec PEGS 10-230V in the language / languages: English as an attachment in your email.

The manual is 1,49 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Trotec PEGS 10-230V

Trotec PEGS 10-230V User Manual - German - 15 pages

Trotec PEGS 10-230V User Manual - Dutch - 15 pages

Trotec PEGS 10-230V User Manual - French - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info