798769
7
Zoom out
Zoom in
Previous page
1/8
Next page
Control Shutdown cycle
The digital control for the BBQ020 comes with an automatic shut down cycle.
When finished cooking on your BBQ020 set the Dial Knob to the off position, this will
leave the Draft Induction Fan running for ten minutes to burn any excess pellets in the
fire pot. After the fan runs for ten minutes the controller will power off and the fan and it
will stop running. CAUTION! The main power switch will shut the power off to the
controller and the Dial Knob switch will cut off power to the grill components only. When
servicing the controller or any parts ensure that the power supply is disconnected to
avoid a shock hazard.
THERMOSTAT CONTROL FUNCTIONS
Adjustment of the “P”(Smoke) settings:- call customer service before adjusting.
Due to the widely varying temperature swings and operating environments experienced
by our customers, the digital controllers contain a function that will allow the grill to
better function in extreme temperature conditions for the smoke function. These
changes should only be performed when the conditions are expected to be present for
extended periods.
In order to access this functionality, locate the small hole on the face plate of the digital
controller just to the right of the red digital display. Turn the controller knob to the 225
setting. Using a very small screwdriver or other pointed object (a bent paper clip works
well), insert into the hole and use it to depress the micro switch located inside. Each
time you depress the switch, the digital readout will change from a temperature display
to a “P” setting followed by a number. The factory default setting is P-2. The setting
range available is from P-0 to P-5 (however it is not recommended that a setting above
5 ever be used). The “P” readout will change each time you depress the micro switch.
With all “P” settings, the Auger motor on time remains constant at 15 seconds while
the Auger motor time off is influenced by the “P” setting.
P-2 Setting (factory): Auger motor on time of 15 seconds, off time: 65 seconds.
P-3 Setting: Auger motor on 15 seconds, off time: 75 seconds
P-4 Setting: Auger motor on 15 seconds, off time: 85 seconds
P-5 Setting: Auger motor on 15 seconds, off time: 95 seconds
Increasing the number decreases the Smoking Temperature. Decreasing the number
increases the Smoking Temperature.
Note: The Traeger Service Department recommends a setting no higher than P-5! Also,
once
a Smoke Adjustment is made, the temperature on the digital readout should be
monitored. If the temperature is consistently below 160 degrees F while “Smoking”,
there is a risk of losing the fire in the firepot. If your fire should go out while “Smoking”,
turn the controller to the OFF POSITION. DO NOT attempt to restart the Grill until you
complete the recovery process (below). Failure to do so could result in an “over firing”
condition and can cause serious damage to your Grill.
Recovery process:
Make sure that the Grill is cool to the touch!
7


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Traeger BAC236 - Digitale Thermostat Kit at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Traeger BAC236 - Digitale Thermostat Kit in the language / languages: English as an attachment in your email.

The manual is 0.45 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info